Husqvarna 917.27909 Service and Adjustments, To Remove Mower See Fig, To Install Mower

Page 20

SERVICE AND ADJUSTMENTS

&WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:Depress clutch/brake pedal fully and set parking brake.

Place gearshift lever in neutral (N) position.

•Place attachment clutch in "DISENGAGED" position.

•Turn ignition key to "STOP"and remove key.

•Make sure the blades and all moving parts have completely stopped.

•Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.

TRACTOR

TO REMOVE MOWER (See Fig. 18)

•Place attachment clutch in "DISENGAGED" position,

•Lower attachment lift lever to its lowest position,

•Disengage belt tension rod from lock bracket,

loaded. Have a tight grip on rod and I

J&CAUTION:slowlyBelt.releasetension rod is spring J

•Remove mower belt from electric clutch pulley,

•DISCONNECT REAR MOWER PINS - Pull out the

spring loaded pin, disconnect suspension arm from pin and release pin.

•Go to other side of mower and disconnect rear pin in the same manner.

•Remove the four retainer springs and two flanged pins from front plate assembly and remove plate,

•Raise attachment lift lever to its highest position,

•Turn tractor steering wheel to the left as far as it will go,

•Slide mower out from under right side of tractor,

TO INSTALL MOWER

Follow procedure described in "INSTALL MOWER AND DRIVE BELT" in the Assembly section of this manual. NOTE: You will need to reattach front plate assembly to tractor after sliding mower under the tractor.

TO LEVEL MOWER HOUSING

Adjust the mower while tractor is parked on level ground or driveway, Make sure tires are properly inflated (See "PRODUCT SPECIFICATIONS" section of this manual), If tires are over or underinflated, you will not properly adjust your mower.

SIDE-TO-SIDE ADJUSTMENT (See Figs. 19 and 20)

•Raise mower to its highest position.

•Measure height from bottom edge of mower to ground level at front corners of mower. Distance "A" on both sides of mower should be the same.

BELTTENSION

ROD

LOCKING BRACKET

 

DISENGAGED

POSITION

 

SUSPENSION ARMS ELECTRIC CLUTCH PULLEY

FRONT PLATE

ASSEMBLY

SINGLE LOOP

.fRETAINER SPRINGS

DOUBLELOOP

RETAINER SPRINGS

FLANGED PINS

REAR MOWER PINS

FIG. 18

20

Page 19 Page 21
Image 20
Page 19 Page 21
Contents Husqvarna II. Slope Operation Safe Operation Practices for Ride-On MowersGeneral Operation Service Safe Operation PracticesIII. Children IV. Towi NGContents Unassembled Parts Tools Required for Assembly CartonBefore Removing Tractor from Skid Unpack CartonInstall Seat See Fig Assemble Gauge Wheels to Mower Deck SeeInstall Mower and Drive Belt Sees Engage slowlyChecklist Checktire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation LOW Choke FastKnow Your Tractor HOW to USE Your Tractor To Adjust Gauge Wheels See Fig Using the Reverse Operation SystemTo Operate Mower See Fig Reverse Operation System ROSBefore Starting the Engine To Operate on HillsTowing Carts and Other Attach Ments Check Engine OIL LevelMowing Tips Maintenance Lubrication ChartGeneral Recommendations Before Each USETo Sharpen Blade See Fig TractorBlade Removal See Fig Battery EngineBelts Transaxle CoolingCleaning Service and Adjustments To Install MowerTo Level Mower Housing To Remove Mower See FigService AdjustmentsMower Drive Belt Installation To Replace Mower Drive BeltMower Drive Belt Removal Belt RoutingTo Replace Motion Drive Belt To Check and Adjust BrakeTo Adjust Attachment Clutch With Parkingbrake Engaged Transmission REMOVAL/REPLACEMENT To Adjust Steering Wheel ALIGN- MentTo Start Engine with a Weak Battery See Fig Front Wheel TOE-IN/CAMBERTo Adjust Throttle Control Cable To Adjust Choke ControlTo Adjust Carburetor To Replace Headlight BulbCylinders Fuel SystemEngine OIL Points Cause CorrectionProblem Cause Correction EngagedSchematic Solenoid Optional Fuel LineElectrical KEY Part Description Chassis and Enclosures Repair Parts Ground Drive Repair Parts Steering Assembly Repair Parts Engine Spark Arrester KITKEY PartSeat Assembly KEY Part DescriptionPart KEY Description DecalsKEY Lift Assembly 11/32 x 1-1/2 x 10 Ga Mower Deck 183 Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXWarranty Statement HusqvarnaHusqvarna

917.27909 specifications

The Husqvarna 917.27909 is a formidable riding lawn mower, designed to offer both power and versatility for homeowners who prioritize efficiency in lawn care. With a robust construction and user-friendly features, this model has garnered attention for its ability to tackle various landscaping tasks.

One of the standout features of the Husqvarna 917.27909 is its powerful engine. Equipped with a 24 horsepower Briggs & Stratton engine, it delivers reliable performance that can handle larger mowing areas without faltering. This engine offers a combination of durability and smooth operation, ensuring that even challenging terrains can be managed with ease.

The cutting deck of the Husqvarna 917.27909 measures 48 inches, allowing for an impressive cutting swath. This wide deck reduces mowing time, making it efficient for expansive yards. The deck is made of high-quality materials that resist wear and tear, and it features an adjustable cutting height to cater to varying grass lengths and user preferences.

An innovative aspect of this mower is its cutting system. The model incorporates a three-blade system that ensures a clean and even cut. This is particularly beneficial for maintaining a healthy lawn, as it prevents grass from being torn and provides a polished finish to the landscape.

User comfort is another key characteristic of the Husqvarna 917.27909. The mower is designed with an ergonomic seat and convenient controls that place essential functions at the operator's fingertips. Additionally, the steering wheel is designed for ease of use, enabling smooth maneuverability around trees and flower beds.

Technologically, the Husqvarna 917.27909 features a hydrostatic transmission, which allows for seamless speed adjustments without the need for manual gear changes. This technology enhances the overall mowing experience by providing intuitive control and the ability to navigate effortlessly across different surfaces.

For maintenance, the model includes practical features such as an easy-access deck wash port. This allows users to connect their garden hose for quick cleaning of the mowing deck, reducing the time spent on upkeep.

In summary, the Husqvarna 917.27909 is a well-engineered riding lawn mower that marries power and convenience. With its strong engine, efficient cutting deck, comfortable user experience, and innovative technology, it stands as a reliable choice for anyone looking to maintain their lawn with minimal effort and maximum results.
Top Page Image Contents