Husqvarna RZ3019 BF/966582101 warranty Fuel Shut Off Valve, Mower Deck Lifting Lever, Tracking

Page 21

CONTROLS

Fuel Shut Off Valve

The fuel shut off valve is located in the fuel line under the seat. Tilt seat forward for access. The fuel valve is ON when the valve is parallel to the fuel line. Rotate the valve ¼ turn clockwise to turn fuel OFF.

IMPORTANT INFORMATION

To obtain an even cutting height, it is important that the air pressure is 15 psi in all tires.

Mower Deck Lifting Lever

The lifting lever is used to place the mower deck in the transport position or one of the 6 different cutting height positions.

The cutting height is set by placing a lever in the notch for the desired cutting height.

The lifting lever can also be used to temporarily adjust the cutting height, such as when passing a minor bump in the lawn.

IMPORTANT INFORMATION

Always use the high position (F) to transport.

Tracking

If the mower is not tracking straight, check the air pressure in both rear tires. Recommended air pressure is 15 psi. (1 bar) Tracking must be checked on a flat and level concrete or blacktop surface.

If the unit still does not track straight contact your Husqvarna workshop for adjustments.

8050-010

Fuel shut off valve in the OPEN position.

8058-085

The mower deck’s lifting lever

21

Image 21
Contents Operator Manual All rights reserved Contents Page Introduction Manufacturing Number Good ServiceXxxx xxxxxx xxxxx xxxx Xxxxxx xxxxxxxxx. xx xxxxxxxx Symbols and DecalsRemove key before Safety Safety InstructionsGeneral Operation Never take passengers Slope Operation Personal Safety EquipmentBe extra cautious when driving on slopes Safe Handling of Gasoline General Maintenance Risk of sparking Spark Arrestor TransportControl Locations ControlsSteering Control Levers Ignition Switch Parking BrakeThrottle Control Refueling Choke ControlMower Deck Lifting Lever Fuel Shut Off ValveTracking Always use the high position F to transportBypass Linkages Blade Control LeverOperation TrainingSteering Starting the Engine Before StartingPlace controls in neutral position Open the fuel valve To remove cables, reverse order Jumper cablesRunning Operating on Hills Mowing Tips Stopping the Engine Moving Machine By Hand Maintenance Schedule Maintenance100 300 Year Battery Cleaning battery and terminalsAlways use protective glasses when handling the battery Tire Pressures Safety SystemBelts Deck BeltTo replace deck belt Cutting Blades EZT BeltLeveling Deck Adjusting the Mower DeckRemoval and installation of caster wheel CleaningUse protective glasses when cleaning and washing Caster WheelsGeneral LubricationFront Wheel Bearings Front Wheel MountDeck Spindle TransmissionProblem Cause TroubleshootingTroubleshooting Service StorageWinter Storage Schematic Technical Data Torque SpecificationsStandard Hardware Transmission 966582101 966612301 EngineOverall dimensions 966582101 966612301 EquipmentProductivity USA Requirements Conformity CertificatesDelivery Service Service JournalAfter 5-10 Hours Hour ServicePerform the 25-hour service At Least Once Each Year Page 115 383627 Rev E 2012-06-30