Husqvarna RZ3016 CA/966612302, RZ3019 BF/966582101 warranty Blade Control Lever, Bypass Linkages

Page 22

CONTROLS

Blade Control Lever

To engage the mower blades, slowly lift the lever up and into the the lock notch.

WARNING!

No adjustments or maintenance to be carried out unless:

the engine stopped

the ignition key removed

the parking brake activated

Bypass Linkages

Transaxle bypass linkages must be engaged when pushing or pulling the mower. The release levers are located on each side of the rear of the unit below the rear engine plate. See Moving Machine By Hand in the Operation section.

WARNING!

Bypass linkages are located close to the muffler. To prevent burns, the engine should be shut off and allowed to cool before the bypass linkage levels are handled.

8058-074

Mower deck blade control lever in the disengaged position

8050-018

Set bypass linkages into slots on both sides

22

Image 22
Contents Operator Manual All rights reserved Contents Page Introduction Good Service Manufacturing NumberSymbols and Decals Xxxx xxxxxx xxxxx xxxx Xxxxxx xxxxxxxxx. xx xxxxxxxxRemove key before Safety Instructions SafetyGeneral Operation Never take passengers Personal Safety Equipment Slope OperationBe extra cautious when driving on slopes Safe Handling of Gasoline General Maintenance Risk of sparking Transport Spark ArrestorControls Control LocationsSteering Control Levers Parking Brake Ignition SwitchThrottle Control Choke Control RefuelingTracking Fuel Shut Off ValveMower Deck Lifting Lever Always use the high position F to transportBlade Control Lever Bypass LinkagesTraining OperationSteering Before Starting Starting the EnginePlace controls in neutral position Open the fuel valve Jumper cables To remove cables, reverse orderRunning Operating on Hills Mowing Tips Stopping the Engine Moving Machine By Hand Maintenance Maintenance Schedule100 300 Year Cleaning battery and terminals BatteryAlways use protective glasses when handling the battery Safety System Tire PressuresDeck Belt BeltsTo replace deck belt EZT Belt Cutting BladesAdjusting the Mower Deck Leveling DeckUse protective glasses when cleaning and washing CleaningRemoval and installation of caster wheel Caster WheelsLubrication GeneralDeck Spindle Front Wheel MountFront Wheel Bearings TransmissionTroubleshooting Problem CauseTroubleshooting Storage ServiceWinter Storage Schematic Torque Specifications Technical DataStandard Hardware 966582101 966612301 Engine Transmission966582101 966612301 Equipment Overall dimensionsProductivity Conformity Certificates USA RequirementsService Journal Delivery ServiceHour Service After 5-10 HoursPerform the 25-hour service At Least Once Each Year Page 115 383627 Rev E 2012-06-30