SETTING UP
Power On/Off
Power on
Sliding the power switch rightward makes power on and off in turn.
When power is applied from the battery or the AC adapter, sliding the power switch make the unit enter standby status.
Sliding the power switch rightward in standby status, the main power is put on and the unit detects existence of the card in the card slot.
If the card in the slot is formatted complying with the units specification, the display blinks showing TOC (Tabel Of Contents) creating message, then enters stop status.
5 | 5 | 5 | 5 | 5 |
| ||||
|
|
| ||
5 |
|
|
| 5 |
5 | 5 | 5 | 5 | 5 |
| ||||
|
| |||
|
|
|
|
About the display in stop status, please refer to the chapter of "Data Display" on page xxx.
If the card is not formatted complying with the unit specification, the display shows unformat message.
If the card does not exist in the card slot, the display shows no card message.
Setting the Date and Time
Before operating your PMD680, perform the following operations to set the current date and time.
The current date and time are recorded automatically at the beginning of each recording.
1With the power off, slide POWER to the right while holding down DISPLAY (TIME/DATE). The unit turns on and enters the date/time setup mode.
2Press 1˜4 or ¢˜¡ to set the year, then press PLAY/PAUSE (3˜8) to enter.
3Press 1˜4 or ¢˜¡ to set the month, then press PLAY/PAUSE (3˜8) to enter.
4Press 1˜4 or ¢˜¡ to set the day, then press PLAY/PAUSE (3˜8) to enter.
5Press 1˜4 or ¢˜¡ to set the hour, then press PLAY/PAUSE (3˜8) to enter.
6Press 1˜4 or ¢˜¡ to set the minute, then press PLAY/PAUSE (3˜8) to enter.
7The seconds start counting from 00 and the unit automatically returns to its normal operation mode (stop status) immediately after you press DISPLAY (TIME/DATE) key. Pressing PLAY/PAUSE (3˜8) instead of DISPLAY (TIME/DATE) key, the minute setting is entered and the menu returns to year setting menu (step 2).
8Pressing STOP (7) before setting minute cancels all the date/time setting.
Power Off
Sliding the power switch rightward while main power is on, the main power is put off after necessary process for shutdown, and the unit enters standby status.
While recording or
4