Husqvarna LZF5227, LZF6127 manual To start an engine with a weak battery, To attach jumper cables

Page 31

OPERATION

To start an engine with a weak battery

WARNING!

Lead-acid batteries generate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See “Battery” in the Maintenance Section.)

If “jumper cables” are used for emergency starting, follow this procedure:

IMPORTANT INFORMATION

Your mower is equipped with a 12-volt negative grounded system. The other vehicle must also be a 12-volt negative grounded system. Do not use your mower to start other vehicles.

To attach jumper cables	8011-642
	Jumper cable connection

•Connect each end of the RED cable to the

POSITIVE (+) terminal on each battery, taking care not to short against chassis.

•Connect one end of the BLACK cable to the

NEGATIVE (-) terminal of the fully charged battery.

•Connect the other end of the BLACK cable to a good CHASSIS GROUND on the mower with the discharged battery, away from the fuel tank and battery.

To remove cables, reverse order

•Remove BLACK cable first from chassis and then from the fully charged battery.

•Remove RED cable last from both batteries.

English-31

Image 31

Contents Operator Manual Page Contents English-4 Introduction Manufacturing Number Good ServiceSymbols and decals Remove key before Safety Instructions SafetyGeneral Operation Never take passengers Slope Operation Personal Safety EquipmentChildren Safe Handling of Gasoline General Maintenance Risk of sparking Customer responsibilities TransportSpark Arresters Roll over Protection system RopsControls Motion Control Levers Tracking knob Hour meterParking Brake Ignition Switch Blade switchFuses Refueling Seat Lock Seat adjustment leverFuel shut off valve Throttle control Choke controlLifting Lever for the Mower Deck Pump release valves Cutting height lift pedalMulching Training OperationSteering Before Starting Roll bar and safety beltStarting the Engine Depress the control for disengaging the mower deck Press in and turn the ignition key to the start position Mowing To attach jumper cables To start an engine with a weak batteryTo remove cables, reverse order Running Mower deck’s gauge wheels should be evenly adjustedOperating on hills Mowing Tips Moving by Hand Stopping the EngineDaily Weekly Least Hours Once Maintenance Before After Each25 50 100 100 300 To clean battery and terminals BatteryReplacing battery Ignition System Safety SystemSafety system Throttle Cable Engine Cooling Air IntakeChoke Cable Air Filter Air Filter Housing And FilterDust Cap Engine Oil Cooler Fuel Pump Air Filter Fuel FilterDeck belt BeltsTo replace deck belt Tire Pressures Pump BeltBlades Blade replacementAdjusting Cutting Height Adjusting the Mower DeckLeveling Hardware Cleaning and WashingRemoval and installation of caster wheel Caster WheelsLubrication Schedule LubricationShaft Bushings and Linkage Lubricating the CablesLubricating with Lubrication Schedule Engine Oil Changing the Engine Oil Checking the Oil Level Oil Type Oil RecommendationsFront Wheel Bearings Mower Deck Height AdjusterThrottle and Choke Cables, Lever Bearings Front Wheel MountMower Deck Struts Steering Control ShaftsChanging the Oil Filter Problem Cause Troubleshooting guideEnglish-58 Storage ServiceWinter Storage Wiring Diagrams LZF5227 LZF6127 Engine Technical DataTransmission LZF5227 LZF6127 Overall DimensionsProductivity Torque Specifications AccessoriesCE requirements USA requirementsDelivery Service Service JournalAction Date, mtr reading, stamp, sign After the First 5-8 Hours Hour Service English-68 English-69 English-70 At Least Once Each Year English-72 English-73 English-74 Page 04/01/08