Husqvarna LT126 instruction manual Hinweis, Remarque, Nota

Page 34

5

02927

Turn the ignition key to “START position”.

NOTE

Do not run the start motor more than 5 seconds at once. If the engine will not start, wait about 10 seconds before the next try.

Zündschlüssel auf “START” drehen.

HINWEIS

Den Anlasser nicht jeweils länger als ca. 5 Sekunden betäti- gen. Wenn der Motor nicht anspringt, vor dem nächsten Anlaßversuch ca. 10 Sekunden warten.

Let the ignition key return to the ”ON” position when the en- gine has started Push the gas control to the required speed. For cutting: full gas.

Warm motor: Push the gas control half-way to full gas position " ".

Bei warmem Motor: Gashebel in die Vollgasstellung " " schieben.

Si le moteur est chaud: pousser la commande des gaz à mi- distance de sa position d'accélération maximale. " ".

Moter caliente: Empuje el acelerador hasta la mitad de su recorrido hacia la posición de plenos gases " ".

Motore caldo: Portare il comando del gas sul massimo " ".

Bij een warme motor: Schuif de gashendel halverwege naar de volgaspositie " ".

Tourner la clef de contact en position de démarrage “START”.

REMARQUE

Ne pas faire tourner le démarreur pendant plus de 5 secondes

àla fois. Si le moteur ne démarre pas, attendre une dizaine de secondes avant de refaire un essai de démarrage.

Ponga la llave de encendido en la posición de arranque ”START”.

NOTA

No haga funcionar el motor de arranque más de unos 5 segundos a la vez. Si el motor no arranca, espere unos 10 segundos antes de hacer otra tentativa.

Girare la chiave su “START”.

NOTA

Non inserire il motorino di avviamento per più di 5 secondi per volta. Se il motore non parte attendere una decina di secondi prima di riprovare.

Draai de startsleutel naar “START”-positie.

N.B.

Laat de startmotor niet langer dan ca 5 sek. per keer draaien. Als de motor niet start, wacht dan ca 10 sek voordat u vol- gende poging doet.

Nach Anspringen des Motors den Zündschlüssel in die Stellung “ON” zurückgehen lassen. Den Gashebel auf die gewünschte Motordrehzahl stellen. Bei Mähen: Vollgas.

Laisser revenir la clef de contact à la position “ON” lorsque le moteur a démarré. Amener la manette de gaz à la position de régime moteur désiré. Pour la coupe, positionner la manette dans l'encoche correspondant au régime moteur optimal pour la tonte (accélération maximale du moteur).

Dejar que la llave de encendido vuelva a la posición “ON” cuando ha arrancado el motor. Ponga el acelerador en la posición deseada. Al cortar, a plenos gases.

Dopo l’avviamento, riportare la chiave su “ON”. Regolare il gas sul regime desiderato. Per il taglio: massimo regime “F”.

Draai de startsleutel terug in “ON”-posotie. Schuif de gash- endel naar het gewenste toerental. Bij maaien: vol gas.

34

Page 33 Page 35
Image 34
Page 33 Page 35
Contents LT126 Page II. Preparation Safety RulesTraining III. OperationIV. Maintenance and Storage II. Vorbereitung SicherheitsvorschriftenSchulung III. BetriebIV. Wartung UND Lagerung II. Préparation Règles de SécuritéPrécautions D’UTILISATION III. UtilisationIV. Entretien ET Entreposage II. Preparación Reglas De SeguridadInstrucción III. OperaciónIV. Mantenimiento Y Almacenamiento II. Preparazione Norme AntinfortunisticheAddestramento ALL’USO III. FunzionamentoIV. Manutenzione E Periodi DI INATTIVITA’ III. Bediening VeiligheidsregelsII. Voorbereiding Maai alleen bij daglicht of goed kunstlicht190 IV. Onderhoud EN Opslag12,5/9,3 As rated by the engine manufacturerReverse Neutral LEA EL Manual DE Sofort Ärztliche Züglich MIT WASExplosive Gase SER Ausspülen Hilfe AufsuchenSteering Wheel Volant DE DirectionVolante DE Dirección LenkradSitz Montieren Install SeatAdjust Seat Einstellen DES SitzesInstalación DEL Asiento Installazione DEL SedileInstallatie VAN DE Stoel Ajustar EL AsientoAccu Installeren Install Battery Einbau DER BatterieInstallazione Della Batteria Mise EN Place DE LA Batterie02604 Positioning of controls Anordnung der BedienungseinrichtungenComandi Emplacement des commandesUbicación de los mandos De plaats van de bedieningsorganen Mandos del acelerador y del estrangulador Commande des gaz et starterGas-und kaltstarthebel Comando gas/chokePédale de frein/D’embrayage Clutch/Brake PedalKupplungs-/Bremspedal Pedal del embrague/FrenoGear shift lever Commande de la boîte de vitessesPalanca de cambios SchalthebelAcoplamiento y desacoplamiento del equipo de corte Commande dembrayage et de débrayage du carter de coupeConnection/disconnection of the cutting unit Inserimento/disinserimento del dispositivo di taglioClé de contact et de démarrage Ignition LockZündschloß Cerradura de encendidoFrein de stationnement Parking brakeFeststellbremse Freno de estacionamientoTanken Filling upReposición de combustible Plein de carburantNiveau d’huile Oil levelÖlstand Nivel de aceiteDriving . Betrieb . Conduite . Conducción Guida . Rijden Remarque HinweisNota Conduite DrivingBetrieb ConducciónSécurité Marche Arrière ROS Reverse Operation System ROSRückwärtsgangsystem ROS Sistema de Funcionamiento Atrás ROSCutting tips Sistema per operazioni in retromarcia ROSSysteem Voor Achteruit ROS Ratschläge zum RasenmähenConsigli per il taglio dell’erba Conseils pour la tonteConsejos para el corte MaaitipsPericolo WarnungAdvertencia WaarschuwingPage Extinction du moteur Switching off the engineAbschalten des Motors Apagar el motorAdvertencia Capot moteur Engine hoodMotorhaube Cubierta del motorEntretien MaintenanceWartung MantenimientoPour assurer lentretien du moteur To service engineWartung des Motors Mantenimiento del motorService Record WartungsnachweisSchema Dentretien Informe DE ServicioService Aantekeningen Dati DI ServizioOperator Presence System and Reverse Opera- tion System ROS Fahrer-Anwesenheitssystem und Rückwärts- gangsystem ROSControllo DEL Sistema DI Presenza Operatore Control Sistema Presencia OperadorControl Sistema DE Funcionamiento Atrás ROS Controllo DEL Sistema PER Operazioni in RE- Tromarcia ROSMesserbalken BladesLames Lame CuchillasMessen Pour vérifier le frein To Check BrakeÜberprüfen der Bremse Controlar el FrenoEntfernen Des Mähers PL QTo Remove Mower Pour Démonter La FaucheusePL QD Sustituir la correa de transmisión cortacésped To Replace Mower Drive BeltAustauschen des Antriebsriemens des Mähers Pour remplacer la courroie de transmissionSostituzione della cinghia di trasmissione del rasaerba De aandrijfriem van de maaiunit vervangenPrecision SIDE-TO-SIDE Adjustment FRONT-TO-BACK AdjustmentVisual SIDE-TO-SIDE Adjustment To Level MowerGenaue justierung an beiden seiten Ausnivellieren des MähersVisuelle Justierung AN Beiden Seiten Gleich sindRéglage Bilatéral DE Précision Pour mettre la tondeuse à niveauRéglage Visuel Bilatéral Réglage D’AVANT EN ArrièreAjuste DE Precisión DE Lado a Lado Nivelar el cortacéspedAjuste Visual DE Lado a Lado Ajuste DE LA Parte Delantera a LA TraseraRegolazione DI Precisione LATO-LATO Livellamento del rasaerbaRegolazione Visiva LATO-LATO Regolazione DAVANTI-DIETROPRECISIE-AFSTELLING BAN Beide Kanten BAN DE Maaiunit De maaiunit nivellerenBeide Kanten OP HET OOG Uitlijnen Afstelling BOOR-EN AchterzijdeTransaxle Gear Shift Lever Neutral Adjustment Einstellung DES Schalthebels DES DifferentialgetriebesPage Auswechsein des Treibriemens Replacement of drive beltRemplacement de la courroie dentraînement Cambio de correa propulsoraTroubleshooting . Störungssuche Recherche des pannes . Búsqueda de averías Ricerca guasti . Het localiseren van fouten Entretien et réparations ServiceStorage . Aufbewahrung . Remisage . Conservación ServicioRismessaggio . Stallen Servizio532 42 24-61 12.10.08 BAD

LT126 specifications

The Husqvarna LT126 is a standout model within the compact lawn tractor market, known for its robust construction, user-friendly design, and versatile features. It is primarily designed for homeowners looking for an efficient and reliable solution for maintaining their lawns. Built with a focus on comfort and ease of use, the LT126 boasts a number of characteristics that enhance both performance and user experience.

One of the key features of the LT126 is its powerful engine. Equipped with a reliable 547cc Briggs & Stratton engine, this tractor ensures efficient performance while providing ample power for routine mowing tasks. The engine is designed with easy starting features and efficient fuel consumption, making it an ideal choice for any yard size.

The LT126 features a 42-inch cutting deck, which enables quick and efficient mowing. This cutting deck is designed with specified cutting heights, allowing users to adjust it according to their lawn's needs. With a simple lever mechanism, users can easily customize their mowing height for a clean, even cut.

Maneuverability is another highlight of the Husqvarna LT126. The tractor is equipped with a tight turning radius, which facilitates easy navigation around obstacles like flower beds and trees. Additionally, the hydrostatic transmission allows for smooth speed adjustments, enabling users to maintain controlled and confident operation even in tight spaces.

Comfort is paramount in the Husqvarna LT126 design. The high back seat provides good back support, allowing users to tackle mowing tasks for extended periods without discomfort. The ergonomically designed steering wheel and pedals ensure that operators can easily maintain control, making the tractor accessible to a wide range of users.

Furthermore, the Husqvarna LT126 integrates advanced technologies, such as the easy-to-use dashboard that provides real-time information about fuel levels, cutting height, and service reminders. This feature ensures that users are constantly informed about their tractor’s performance, contributing to overall maintenance and efficiency.

The model also supports optional attachments, such as mulching kits, baggers, and snow blades, making it a versatile tool for year-round yard care. This adaptability allows homeowners to maximize their investment by utilizing the tractor beyond traditional mowing.

In summary, the Husqvarna LT126 is a powerful and versatile lawn tractor that combines efficiency, comfort, and advanced technology. With its emphasis on user-friendly features and adaptability, it stands out as an essential tool for maintaining a beautiful lawn, making it an excellent choice for both novice and experienced lawn care enthusiasts.
Top Page Image Contents