CONTROLS
4. By pass linkages
When pushing or pulling the mower, be sure to engage the IZT (Integraded Zeroturn Transaxle) bypass linkages. The IZT bypass linkages are located on the rear of the frame, below the rear engine guard.
•Raise the deck into the highest cutting position.
•Pull the IZT bypass linkages out and into the slots and release so that it is held in the bypass position.
•To reengage the IZT’s to drive, reverse the above procedure.
1.IZT Bypass linkage Bypass linkages
1.Head outside of rear deck
2.IZT Bypass linkage in bypass position Bypass position