LUBRICATION
The oil level should lie between the markings on the dipstick. If the level is approaching the ”ADD” mark, fill the oil to the ”FULL” mark on the dipstick.
Never fill above the ”FULL” mark.
The oil is filled through the hole for the dipstick.
Use engine oil SAE 30 or SAE
(over +32 °F/0 °C).
Over +68 °F/+20 °C SAE 40 can be used.
Use engine oil SAE
The engine holds 1.6 qt/1.5 liters of oil excluding the filter (including filter 1.8 qt/1.7 liters).
4.Throttle and Choke Cables, Lever Bearings
Lubricate the cable ends by the carburetor with a oil can. Move the controls to the end points and lubricate again.
The throttle cable is also lubricated by the control when the control console is removed.
The illustration shows the Kawasaki engine.
On Kohler engine the cables are placed under the air filter housing.
5. Front Wheel Mount
Lubricate with a grease gun, one zerk for each wheel mount, until the grease is forced out.
Use only good quality molybdenum disulphide grease.
Grease from
The dipstick markings
Engine oils
Throttle and choke cables by the carburetor