To adjust anti-scalp rollers
Anti-scalp rollers are properly adjusted when they are just slightly off of the ground when the deck is at the desired cutting height in the operating position. Anti-scalp rollers then keep the deck in the proper position to help prevent scalping in most terrain conditions.
IMPORTANT INFORMATION
Adjust Anti-scalp rollers with the mower on a flat level surface.
Tunnel Deck -
The anti-scalp rollers can be set in three positions.
¥Upper position 1.5 to 3 (38 to 76 mm) grass.
¥Middle position 3 to 4.5 (76 to 114 mm) grass.
¥Lower position 4.5 to 6 (114 to 152 mm) grass.
Combi Deck -
The anti-scalp rollers can be set in two postions.
¥Upper position 1.5 to 3 (38 to 76mm) grass.
¥Lower position 3 to 5 (38 to 127mm) grass.
The rollers should be approximately 1/4 (6.5 mm) from ground.
IMPORTANT INFORMATION
The anti-scalp rollers must not be used for gauge wheels or the roller and deck may be damaged.
