Husqvarna IZ 21 manual Engine Oil Changing the Engine Oil, Checking the Oil Level

Page 56

LUBRICATION

3. Engine Oil

Changing the Engine Oil

The engine oil shall be changed for the first time after 8 hours of operation. Thereafter, it should be changed every 100 hours.

WARNING!

The engine and the exhaust system, become very hot during operation.

Risk for burns if touched.

Allow engine and exhaust sytem to cool at least two (2) minutes.

1.Place the machine on a flat surface.

2.Place a container under the engine drain plug.

3.Remove the dipstick and open the drain plug.

4.Allow the oil to run out into the container.

5.Install and tighten the oil drain plug.

6.Replace the oil filter if necessary.

7.Fill with new engine oil in accordance with Checking the Oil Level.

8.Start the engine. Run it for a few seconds. Stop and re-check the oil level.

IMPORTANT INFORMATION

Used engine oil is a health hazard and must not be disposed of on the ground or in nature; it should always be disposed of at a workshop or appropriate disposal location.

Avoid skin contact; wash with soap and water in case of spills.

8011-455

Oil drain plug Kawasaki

Checking the Oil Level

Check the oil level in the engine when the machine is standing level and the engine is stopped.

Remove the dipstick, wipe it clean, and then replace it.

The dipstick should not be screwed into place.

Take the dipstick out again and read the oil level.

8011-569

Remove the dipstick

English-54

Image 56
Contents Operator´s manual EnglishPage Contents Operator S Manual RiderEnglish-2 Introduction IntroductionGood Service Manufacturing NumberXxxxxxx xxxx xxxxxxxx xxx Xxxx xxxxxx Symbols and DecalsSymbols and Decals Passengers General Operation Safety InstructionsSafety Instructions English-8 Personal Safety Equipment Slope OperationChildren Maintenance General Maintenance Risk of sparking Transport Customer responsibilities Control Locations ControlsControls Motion Control Levers Parking Brake Hour MeterTracking Knob Fuses Blade switchIgnition Switch Seat Locking Device RefuelingChoke Control Seat Adjustment LeverFuel Shut Off Valve Throttle Control Lifting Lever for the Mower DeckAccessories Pump release valvesCutting height pedal Tunnel Deck OnlyTraining OperationOperation Before Starting Starting the EngineDisengage the mower blades by depressing the blade switch Press in and turn the ignition key to the start position USE Full Throttle When Mowing To start an engine with a weak battery To remove cables, reverse orderRunning Operating on hills Mowing Tips Stopping the Engine Moving by Hand Maintenance MaintenanceMaintenance Schedule MaintenanceBefore After Battery To clean battery and terminalsReplacing battery Always use protective glasses when handling the batteryIgnition System Checking the Safety System Safety system Checking the Engine’s Cooling Air Intake Checking and Adjusting Throttle CableChecking and Adjusting the Choke Cable Replacing the Air Filter Standard air filterCyclon air filter maintenance Filter replacement Air filter indicator optionalReplacing the Fuel Filter Checking the Fuel Pump s Air FilterFaulty adjustment can cause an accident Checking Tire PressuresChecking the Parking Brake Checking the V-beltsChecking the Blades Pump beltBlade attachment Adjusting the Mower Deck Adjusting Cutting HeightTo adjust anti-scalp rollers Cleaning and Washing Use protective glasses when cleaning and washingRemoval and installation of caster wheel Caster WheelsLubrication Schedule LubricationLubrication Lubricating in Accordance with the Lubrication Schedule Lubricating the CablesShaft Bushings and Linkage Engine Oil Changing the Engine Oil Checking the Oil LevelThrottle and Choke Cables, Lever Bearings Front Wheel MountDeck belt pulleys Tunnel Deck Only Mower Deck Height AdjusterFront Wheel Bearings Belt Adjuster, Mower Deck Mower Deck StrutsBrake Arms Changing the Oil Filter Problem Cause Trouble Shooting GuideTrouble Shooting Guide English-61 Service StorageStorage Winter StorageWiring Diagrams Wiring diagramTechnical Data Engine IZ21CManufacturer TransmissionIZ21C Tunnel Deck Combi Deck Metric Standard Hardware AccessoriesStandard Hardware Conformity Certificates Conformity Certificates For Model Listed BelowBusiness Name & Address Notified BodyService Journal Service JournalDelivery Service Action Date, mtr reading, stamp, signEnglish-69 Hour Service English-71 English-72 English-73 At Least Once Each Year English-75 English-76 Page Original instructions 115 36 2010W19