Husqvarna GTH27V52LS owner manual To Replace Motion Drive Belt See Fig, Front Wheel TOE-IN/CAMBER

Page 22

SERVICE AND ADJUSTMENTS

TO REPLACE MOTION DRIVE BELT (See Fig. 38)

Park the tractor on level surface. Engage parking brake. For assistance, there is a belt installation guide decal on bottom side of left footrest.

BELT REMOVAL -

1.Remove mower (See “TO REMOVE MOWER” section in this manual).

NOTE: Observe entire motion drive belt and position of all belt guides and keepers.

2.Disconnect clutch wire harness (A).

3.Remove anti-rotation link (B) on right side of tractor.

4.Remove belt from stationary idler (C) and clutching idler (D).

5.Pull belt slack toward rear of tractor. Carefully remove belt upwards from transmission input pulley and over cooling fan blades (F).

6.Remove belt downward from engine pulley and around electric clutch (G).

7.Slide belt toward rear of tractor, off the steering plate

(H) and remove from tractor.

G

H

B

A

C

J

D

F

Fig. 38

BELT INSTALLATION -

1.Install new belt from tractor rear to front, over the steer- ing plate (H) and above clutch brake pedal shaft (J).

2.Pull belt toward front of tractor and roll belt around electric clutch and onto engine pulley (G).

3.Pull belt toward rear of tractor. Carefully work belt down around transmission cooling fan and onto the input pulley (F). Be sure belt is inside the belt keeper.

4.Install belt through stationary idler (C) and clutching idler (D).

5.Reinstall anti-rotation link (B) on right side of tractor. Tighten securely.

6.Reconnect clutch harness (A).

7.Make sure belt is in all pulley grooves and inside all belt guides and keepers.

8.Install mower (See “TO INSTALL MOWER” section in this manual).

FRONT WHEEL TOE-IN/CAMBER

Your new tractor front wheel toe-in and camber is set at the factory and is normal. The front wheel toe-in and camber are not adjustable. If damage has occurred to affect the factory set front wheel toe-in or camber, contact a qualified service center.

TO REMOVE WHEEL (See Fig. 39)

Block up axle securely.

Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not lose).

Repair tire and reassemble.

On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.

Replace washers and snap retaining ring securely in axle groove.

Replace axle cover.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

WASHERS

RETAINING

RING

AXLE COVER

SQUARE KEY (REAR

WHEEL ONLY)

Fig. 39

22

Image 22
Contents GTH27V52LS General Operation Safety RulesSafe Operation Practices for Ride-On Mowers II. Slope OperationIII. Children ServiceGeneral Service IV. TowingTable of Contents Unassembled Parts AssemblyTools Required for Assembly ToremovetractorfromcartonCheck for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemOperation Know Your Tractor To SET Parking Brake See Fig HOW to USE Your TractorAttachment Clutch Switch Disengaged Engaged Stopping See FigTo Move Forward and Backward See Fig To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To USE Cruise Control J See FigReverse Operation System ROS See Fig Using the Reverse Operation SystemTo Stop Mower Blades To Operate on HillsCheck Engine OIL Level Service REMINDER/HOUR MeterBefore Starting the Engine ADD GasolinePurge Transmission Mowing TipsAutomatic Transmission Warm UP General Recommendations MaintenanceMaintenance ScheduleBlade Care BatteryTractor Blade Removal See FigEngine IN-LINE Fuel Filter See Fig CleaningDeck Washout Port See Fig Install ANTI-SWAY BAR S if Equipped Service and AdjustmentsTo Install Mower See Fig To Remove Mower See FigSecure with small washer and small retainer spring as shown To Level Mower To Replace Mower Blade Drive Belt To Check BrakeFront Wheel TOE-IN/CAMBER Belt InstallationTo Replace Motion Drive Belt See Fig To Remove Wheel See FigReplacing Battery See Fig To Start Engine with a Weak Battery see FIGTo Remove CABLES, Reverse Order Transmission Fuel System StorageOther Engine OILTroubleshooting Points Problem Cause CorrectionEngine continues Service Notes Service Notes Service Notes Ggus 01.07.09 AP

GTH27V52LS specifications

The Husqvarna GTH27V52LS is a robust and versatile riding lawn tractor designed to provide an optimal mowing experience for homeowners with larger landscapes. Known for its powerful performance and advanced features, this model stands out as a reliable choice for tackling various lawn care tasks.

At the heart of the GTH27V52LS is its 27-horsepower Kohler engine, delivering ample power to handle expansive lawns with ease. The efficient engine provides a balance between performance and fuel economy, ensuring you can work for longer periods without frequent refueling. Additionally, the hydrostatic transmission allows for smooth, infinite speed control, making it simple to maneuver around obstacles and navigate uneven terrain.

One of the standout features of the GTH27V52LS is its 52-inch cutting deck, which provides an impressive cutting width for efficient mowing of large areas. The deck is designed with oversized tires that enhance traction and stability, ensuring a clean cut even on the toughest terrains. Furthermore, the deck height can easily be adjusted to suit varying grass lengths, enabling precise cutting for a polished finish.

The GTH27V52LS incorporates innovative mowing technologies, such as the Air Induction Mowing Technology, which improves airflow within the deck for a superior grass cutting and grass collection performance. This results in a healthier lawn with minimal clumping and enhanced mulching capabilities.

Comfort is also a priority in the design of the GTH27V52LS. The spacious, ergonomic seat offers ample cushioning and adjustable settings, ensuring a comfortable ride during extended mowing sessions. The easy-to-use controls are strategically located for convenience, enabling operators to maintain focus on the task at hand without interruptions.

Additional features include an integrated roll-over protection system for added safety, as well as a range of accessories, such as baggers and tow-behind attachments, that enhance the tractor’s functionality throughout the year. The durable construction and high-quality materials ensure that the Husqvarna GTH27V52LS is built to withstand the rigors of regular use, making it a long-lasting investment for any homeowner.

In summary, the Husqvarna GTH27V52LS combines power, technology, and user-friendly design, making it an outstanding choice for anyone in need of a reliable riding lawn tractor. Its exceptional performance and innovative features provide an efficient solution for maintaining large lawns, ensuring your outdoor space remains pristine year-round.