Husqvarna Z18 manual To start an engine with a weak battery, To remove cables, reverse order

Page 29

OPERATION

To start an engine with a weak battery

WARNING!

Lead-acid batteries generate explosive gases. Keep sparks, ﬂame and smoking materials away from batteries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See “Battery” on page 33).

If “jumper cables” are used for emergency starting, follow this procedure:

IMPORTANT INFORMATION

Your mower is equipped with a 12-volt negative grounded system. The other vehicle must also be a 12-volt negative grounded system. Do not use your mower battery to start other vehicles.

To attach jumper cables

• Connect each end of the RED cable to the POSITIVE (+) terminal on each battery, taking care not to short against chassis.

•Connect one end of the BLACK cable to the NEGATIVE (-) terminal of the fully charged battery.

• Connect the other end of the BLACK	8011-642
	8011-642
cable to a good CHASSIS GROUND on	Jumper cables connection
the mower with the discharged battery,
away from the fuel tank and battery.

To remove cables, reverse order

•Remove BLACK cable ﬁrst from chassis and then from the fully charged battery.

•Remove RED cable last from both batteries.

English-27

Image 29

Contents English Z18Page OPERATOR’S Manual Rider Series ContentsEnglish Introduction IntroductionManufacturing Number Good ServiceXxxxxxx xxxx xxxxxxxx xxx Xxxx xxxxxx Symbols and DecalsSymbols and Decals Passengers General Use Safety InstructionsSafety Instructions Hearing Do not Driving on SlopesDo as follows Utility Box ChildrenMaintenance Risk of sparking Transport Use protective glasses for maintenance workCustomer responsibilities Control Locations ControlsControls Tracking Motion Control LeversFuses Seat adjustment knobsBy pass linkages Refueling Blade switchThrottle Control Ignition SwitchChoke Control Machine must be stopped before activating the parking brake Hour MeterParking Brake Cutting height pedal AccessoriesTraining OperationOperation Starting the Engine Before StartingDisengage the mower blades by depressing the blade switch Press in and turn the ignition key to the start position To remove cables, reverse order To start an engine with a weak batteryRunning Operating on hills Mowing Tips Stopping the Engine Moving by Hand Maintenance Schedule MaintenanceMaintenance = Described in this manual = Not described in this manual Replacing battery BatteryTo clean battery and terminals Ignition System Checking the Safety System Checking the Engines Cooling Air Intake Checking and Adjusting Throttle CableKohler engine Replacing the Air FilterInstall the cover and tighten the knobs by Replacing the Fuel Filter Faulty adjustment can cause an accidentChecking Tire Pressures Checking the Parking BrakeDeck belt Checking the V-beltsDeck belt installation EZT belt removal EZT beltTo replace EZT E-Series Zeroturn Transaxle belt Checking the Blades Always use protective gloves when handling the bladesAdjusting the Mower Deck To level deck Side-to-side adjustmentFront-to-back adjustment To adjust anti-scalp rollers Use protective glasses when cleaning and washing Cleaning and WashingCaster Wheels HardwareLubrication Schedule LubricationLubricating in Accordance with the Lubrication Schedule Lubricating the CablesCaster wheels Engine Oil Briggs & Stratton Changing the Engine OilOil drain valve Checking the oil level Engine oil Kohler Changing the engine oil Transmission Changing the Oil FilterProblem Cause Trouble Shooting GuideTrouble Shooting Guide Trouble Shooting Guide English-59 Storage ServiceStorage Winter StorageWiring diagram Wiring DiagramsZ18 Technical DataTechnical Data Equipment Torque Speciﬁcations Conformity Certiﬁcates Conformity CertificatesService Journal Service JournalDelivery Service ActionAfter the First 5-8 Hours Hour Service English-69 Service Journal English-71 At Least Once Each Year Action Date, mtr reading, stamp, sign Service Journal English-75 ´z+RP¶6P¨ English-77 115 04 ´z+RP¶6P¨ ´z+RP¶6P¨