Husqvarna Z18 manual Engine oil Kohler Changing the engine oil

Page 57

LUBRICATION

2.Engine oil (Kohler) Changing the engine oil

The engine oil should be changed for the ﬁrst time after 5-8 hours of operation. Thereafter, it should be changed every 50 hours.

WARNING!

Engine oil can be very hot if it is drained directly after stopping the engine. Allow the engine to cool somewhat ﬁrst.

1.Place the machine on a ﬂat surface.

2.Place a container under the engine where the oil drain exits.

IMPORTANT INFORMATION

Used engine oil is a health hazard and must not be disposed of on the ground or in nature; it should always be disposed of at a workshop or appropriate disposal location.

Avoid skin contact; wash with soap and water in case of spills.

8011-740

Oil drain plug Kohler

3.Remove the dipstick and open the drain plug.

4.Allow the oil to run out into the container.

5.Install and tighten the oil drain plug.

6.Replace the oil ﬁlter if necessary.

7.Fill with new engine oil in accordance

with Checking the Oil Level.

8. Start the engine. Run it for a few seconds and re-check the oil level.

8011-741

Dipstick

English-55

Image 57

Contents English Z18Page OPERATOR’S Manual Rider Series ContentsEnglish Introduction IntroductionManufacturing Number Good ServiceSymbols and Decals Symbols and DecalsXxxxxxx xxxx xxxxxxxx xxx Xxxx xxxxxx Passengers Safety Instructions Safety InstructionsGeneral Use Hearing Driving on Slopes Do as followsDo not Utility Box ChildrenMaintenance Risk of sparking Transport Use protective glasses for maintenance workCustomer responsibilities Controls ControlsControl Locations Tracking Motion Control LeversFuses Seat adjustment knobsBy pass linkages Refueling Blade switchIgnition Switch Choke ControlThrottle Control Hour Meter Parking BrakeMachine must be stopped before activating the parking brake Cutting height pedal AccessoriesOperation OperationTraining Starting the Engine Before StartingDisengage the mower blades by depressing the blade switch Press in and turn the ignition key to the start position To remove cables, reverse order To start an engine with a weak batteryRunning Operating on hills Mowing Tips Stopping the Engine Moving by Hand Maintenance MaintenanceMaintenance Schedule = Described in this manual = Not described in this manual Battery To clean battery and terminalsReplacing battery Ignition System Checking the Safety System Checking the Engines Cooling Air Intake Checking and Adjusting Throttle CableKohler engine Replacing the Air FilterInstall the cover and tighten the knobs by Replacing the Fuel Filter Faulty adjustment can cause an accidentChecking Tire Pressures Checking the Parking BrakeDeck belt Checking the V-beltsDeck belt installation EZT belt To replace EZT E-Series Zeroturn Transaxle beltEZT belt removal Checking the Blades Always use protective gloves when handling the bladesAdjusting the Mower Deck To level deck Side-to-side adjustmentFront-to-back adjustment To adjust anti-scalp rollers Use protective glasses when cleaning and washing Cleaning and WashingCaster Wheels HardwareLubrication Schedule LubricationLubricating in Accordance with the Lubrication Schedule Lubricating the CablesCaster wheels Engine Oil Briggs & Stratton Changing the Engine OilOil drain valve Checking the oil level Engine oil Kohler Changing the engine oil Transmission Changing the Oil FilterTrouble Shooting Guide Trouble Shooting GuideProblem Cause Trouble Shooting Guide English-59 Storage ServiceStorage Winter StorageWiring diagram Wiring DiagramsTechnical Data Technical DataZ18 Equipment Torque Speciﬁcations Conformity Certiﬁcates Conformity CertificatesService Journal Service JournalDelivery Service ActionAfter the First 5-8 Hours Hour Service English-69 Service Journal English-71 At Least Once Each Year Action Date, mtr reading, stamp, sign Service Journal English-75 ´z+RP¶6P¨ English-77 115 04 ´z+RP¶6P¨ ´z+RP¶6P¨