Husqvarna Z4818BIA/968999250 manual Hour Meter, Choke Control, Ignition Switch

Page 23

CONTROLS

9. Hour Meter

The hour meter displays the total operating time.

It will flash CHG OIL (Change Oil) at 50 hour intervals. The flash duration is one hour before and one hour after the interval. The CHG OIL icon will come on and shut off automatically. The hour meter can not be manually reset.

8011-759

Hour meter

10. Choke Control

The choke control is used for cold starts in order to provide the engine with a richer fuel mixture.

For cold starts the control should be pulled out.

8011-756

Choke control

11. Ignition Switch

The ignition key is placed on the control panel and is used to start and stop the engine.

IMPORTANT INFORMATION

Do not run the starter for more than five seconds each time. If the engine does not start, wait about 10 seconds before re- trying.

8011-758

Ignition key

English-21

Image 23

Contents Z4818BIA/968999250 Page OPERATOR’S Manual Rider English-2 Introduction IntroductionManufacturing Number Good ServiceXxxxxxx xxxx xxxxxxxx xxx Xxxx xxxxxx Symbols and DecalsSymbols and Decals Greater Than Careful General Use Safety InstructionsSafety Instructions Hearing Do not Driving on SlopesDo as follows Children Maintenance Poisonous, and lethal gas Transport Use protective glasses for maintenance workCustomer responsibilities Control Locations ControlsParking Brake Tension Relief LeverTracking Motion Control LeversFuel Shut Off Valve Seat adjustment knobsRefueling Fuses By pass linkageChoke Control Ignition SwitchHour Meter Throttle Control Blade switchCutting height pedal AccessoriesTraining OperationOperation Starting the Engine Before StartingDepress the control for disengaging the mower deck Set the choke control USE Full Throttle When Mowing To remove cables, reverse order To start an engine with a weak batteryRunning Operating on hills Mowing Tips Stopping the Engine Moving by Hand Maintenance Schedule MaintenanceMaintenance = Described in this manual = Not described in this manua Replacing battery BatteryTo clean battery and terminals Ignition System Checking the Safety System Checking the Engines Cooling Air Intake Checking and Adjusting the Throttle CableChecking and Adjusting the Choke Cable Standard air filter Replacing the Air FilterChecking Tire Pressures Replacing the Fuel FilterChecking the Fuel Pump’s Air Filter Deck belt Faulty adjustment can cause an accidentChecking the Parking Brake Checking the V-beltsDeck belt installation IZT belt removal Belt installationIZT belt To replace IZT Integraded Zeroturn Transaxle beltChecking the Blades Always use protective gloves when handling the bladesRemove blade bolt by turning counterclockwise Adjusting the Mower Deck To level deck Side-to-side adjustmentFront-to-back adjustment To adjust anti-scalp rollers Caster Wheels Cleaning and WashingUse protective glasses when cleaning and washing Removal and installation of caster wheelMower is tracking to the right Tracking adjustmentTo adjust parking brake Parking brakeLubrication Schedule LubricationLubrication Front Wheel Bearings Lubricating the CablesLubricating in Accordance with the Lubrication Schedule Front Wheel MountEngine Oil Changing the Engine Oil Deck outer spindleChecking the Oil Level Transmission Changing the Oil FilterProblem Cause Trouble Shooting GuideTrouble Shooting Guide Water in the fuel English-61 Winter Storage ServiceStorage StorageWiring diagram Wiring DiagramsZ4818BIA Technical DataTechnical Data Productivity Torque Specifications AccessoriesUSA requirements Conformity CertificatesAction Date, mtr reading, stamp, sign Service JournalService Journal Delivery ServiceAfter the First 5-8 Hours Hour Service English-71 English-72 English-73 At Least Once Each Year English-75 109797R0108/10/05