JBL Professional DP SERIES AC Power Module, Input Module Controls, Indicators and Connectors

Page 18

AC Power Module

POWER Indicator:

Blue LED – located near power inlet lights when AC power is applied.

Amp READY Indicator:

Green LED near power inlet, ON during normal operation, long pulse during sleep mode.

Sleep Mode:

If audio input signals are not detected for 2 hours, the amplifier will go into sleep/standby mode; the amplifier output section is turned off while the supply powering the DP Input Module and DSP logic remains active. This mode reduces current draw and heat loss.

While in sleep mode the READY indicator pulses slowly. Recovery from sleep mode is instantaneous when an audio signal is detected

.

Thermal Management:

JBL DrivePack® systems are cooled by Passive Convection. No fans are used in any part of the thermal management system. To maintain

efficient cooling it is a good practice to assure open space around the DrivePack units.

Operating Temperature:

The system will remain touchable during quiescent operation and will not provide a burn hazard during any operating condition.

Input Module Controls, Indicators and Connectors

JBL DrivePack® systems are equipped with a modular input bay and input modules are available in three versions in the VERTEC DP Series: the DPIP, DPAN and the DPCN.

Audio Signal Distribution

Connecting source audio signals to the input modules on JBL DrivePack systems is similar to daisy-chaining multiple external amplifier channels together.

Assuming an output device source impedance of 100 Ohms and a 10:1 load to source ratio, up to 20 JBL DrivePack units typical can be linked together on one output source without using a distribution amp.

NOTE: Please refer to VERTEC DP Series spec sheets for additional features and specifications of the DPIP, DPAN and DPCN input modules.

18 VERTEC User’s Guide

Image 18
Contents Product User’s Guide Vertec User’s Guide Table of Contents Safety Instructions CSA Compliance Notice Safety and EMC Compliance Specifications JBL Drivepack Declaration of ConformityBefore YOU Begin Vertec DP Series Compact Powered Systems 1x18 subwoofer systemVertec DP SERIES, Compact Powered Systems Specifications Vertec DP Series Transducers 2408H High Frequency Compression DriverEnclosure Care and Maintenance Painting JBL Vertec DP Series System ProductsSafety Precautions Rigging and SuspensionGeneral Hardware Information Rigging Hardware Inspection & MaintenanceAre You New to Rigging? Attachment to StructuresIndustry Resources Safe RiggingDrivePack Signal-Processing & Amplification Unit JBL Drivepack TechnologyIntroduction to JBL DrivePack Integrated Audio System User-Fabricated AC Cable and Connector Information Power Connector CodingDP2 AC Power Ratings DP1 AC Power RatingsAC Power Module Input Module Controls, Indicators and ConnectorsDpip Standard Input Module Thermal Protection Enable ALT Preset buttonIndicators Enable ALT Preset ReadyAudio OUT Network 100MB LinkAudio MAC Address Window11a & 11b CobraNet 12a & 12b Network 100MB Link10a & 10b CobraNet Primary and Secondary Network Connectors Protective Jackets for Input and AC Power Modules Protective Jacket InstallationJBL Professional AS-SHIPPED Ethernet Configuration System Architect SoftwareIntroduction Setting up a Simple Isolated Ethernet Network Using Dhcp Network Setup with Dhcp Working with a Network of Multiple JBL DevicesDisable DHCP/AUTO Hiqnet Address in System Architect Vertec User’s Guide Glossary of Terms Appendix a Configuring Cobranet Primary and Secondary Network Ports Dualink Switched NetworksPriority Repeater NetworksAppendix B Setting Windows to the Standard Font Size JBL Professional Vertec User’s Guide JBL Limited Warranty Exclusion of Certain DamagesJBL Contact Information WEB LinksJBL Professional VTDP-C Prod Guide