Installation
You can install the product in one of the following three ways:Choose a desired one according to the installation area and your decoration plan.
Installing on the Table Stand
1. Fit the rear round side of the product into the | 1 |
|
|
stand holes and fix it with 4 small black |
|
| |
screws(4x12). |
|
|
|
- Ensure that you insert it in the right direction. |
|
|
|
|
|
|
|
|
|
|
|
properly on the table stand. | 2 |
Installing on a Tallboy Type of Stand
If you want to place the product vertically on the floor, use a Tallboy type of stand featuring the stand base and pole. Proceed with the installation considering the size, installation area and position of the Tallboy stand.
1. Insert the system cable through the stand base | 1 |
|
|
|
| ||
hole. |
|
| |
- The small port should be revealed from the top |
|
|
|
of the stand base so that you connect the |
|
|
|
product to it. |
|
|
|
|
|
|
|
|
|
|
|
2. Loosen the screw on one end of the bracket- | 2 |
cable in the bottom of stand base and turn the | |
| |
through the bottom hole and turn the bracket |
|
cable back to the original. Then, tighten it with |
|
the screw. |
|
|
|
English 19
Started Getting 01