1.First, shut off the main water supply line.
2.Locate the nearest cold, drinking water line.
3.Follow the Water line Installation Instructions in the installation kit.
CAUTION
The water line must be connected to the cold water pipe. If it is connected to the hot water pipe, it may cause the purifier to malfunction.
Close Main
Close Main | No gap | |
Water pipe | ||
|
Connecting the water line to the refrigerator
1.Remove the cap from water line on the unit and insert compression nut to the water line on the unit after disassembling from provided water line.
2.Connect both water line from the unit and water line in the kit.
3.Tighten the compression nut onto the compression fitting. There should be no gaps between
(A, B & C )
4.Turn water on and check for any leakage.
Remove
Only connect the water line to a drinkable water source.
If you have to repair or disassemble the water line, cut off 6.5mm of the plastic tubing to make sure you get a snug,
After the water supply has been installed CAUTION check all the joints to ensure there are no
leaks.
•Samsung Warranty does
not cover THE WATER
LINE INSTALLATION.
• The cost of the water line installation is at the
customers expense, unless the retailer has covered this expense in the delivery charge.
•Please contact a Plumber or Authorized Installer for the installation if needed.
•If Water leakage occurs due to improper installation, Please contact installer.
SETTING UP THEREFRIGERATORNow that you have your new Refrigerator installed in place, you are ready to set up and enjoy the features and functions of the appliance. By completing the following steps, your Refrigerator should be fully operational.
1. | Place the Refrigerator in an appropriate location |
| with reasonable clearance between the wall and |
| the Refrigerator. Refer to installation instructions |
| in this manual. (P8. Selecting the best location for |
2. | the Refrigerator) |
Once the Refrigerator is plugged in, make sure | |
| the interior light comes on when you open the |
3. | doors. |
Set the Temperature control to the coldest | |
| temperature and wait for an hour. The Freezer |
Loosen a
cap
will get slightly chilled and the motor will run |
smoothly. |
4. After powering the Refrigerator, it will take a few |
hours to reach the appropriate temperature. You |
Water Line
from unit
No gap
Water Line
from unit
can store food and drinks in the Refrigerator after |
the temperature is sufficiently cool. |
14_ setting up