electrical parts may cause an electric shock or fire.
•Do not place this refrigerator in direct sunlight or expose to the heat from stoves, room heaters or other appliance.
•Do not plug several appliances into the same multiple power board.
The refrigerator should always be plugged into its own
individual electrical which has a voltage rating that matched the rating plate.
-This provides the best performance and also
prevents overloading house wiring circuits, which could cause a fire hazard from overheated wires.
•If the wall socket is loose, do not insert the power plug.
-There is a risk of electric shock of fire.
•Do not use a cord that shows cracks or abrasion damage along its length or at either end.
•Do not bend the power cord excessively or place heavy articles on it.
•Do not use aerosols near the refrigerator.
-Aerosols used near the refrigerator may cause an
explosion or fire.
• This refrigerator must be properly installed and located in accordance with the manual before it is used.
•Connect the power plug in proper position with the cord
hanging down.
-If you connect the power plug upside down, wire can get cut off and cause fire or electric shock.
•Make sure that the power plug is not squashed or damaged by the back of the refrigerator.
•When moving the refrigerator, be careful not to roll over or
damage the power cord.
-This constitutes a fire hazard.
• The appliance must be positioned so that the plug is accessible after installation.
• The refrigerator must be grounded.
-You must ground the refrigerator to prevent any power leakages or electric shocks caused by current leakage from the refrigerator.
•Never use gas pipes,
04_ safety information