Samsung SHR-5082P SPOT-OUTMONITORING, STOP, STOP, MODE, LIVE, Failure, live _19, personnel, Monitoring, Fan Information, Spot Out Channel, Refer to the manual

SPOT-OUT MONITORING

Spot-out monitoring has nothing to do with the live screen output. It monitors a specific channel in full screen. After selecting Monitoring on the MENU, you can select a channel for monitoring in Spot Out Channel. You can also monitor all the channels at an interval of auto sequence time.

In case of spot-out monitoring, the live screen icons do not appear.If the Spot Out Event Monitor is set to On, you can see the event channels.

When the events occur sequentially, the channel of the camera that the last event has been issued is displayed. (In case of alarms, multiple channels are enabled.)

When multiple cameras are connected, the camera with the smallest number is output on Spot-out channel.

In the live screen, you can select a spot- out channel as described below:

Press the STOP button on the front panel or remote control and press a button out of 16 channels. The selected channel is set to a spot-out channel.

When you press the STOP button and then the MODE button within 2 seconds, the spot-out channel mode is changed to the change screen mode.

If the built-in HDD is not connected

CAUTION	or it is out of order, the system
	displays an error ( ) saying “built-
	in HDD error” at the top-left corner.
	In this case, you cannot perform
	recording, playback, and backup.
	So please contact the service
	personnel.

If the fans in the product do not properly operate or have some problem, the fan error message appears on the live screen as shown in the following picture. In this case, check whether the fans

normally run or not. When the fans are recovered, the Failure icon (

) that is displayed at the top- left corner disappears. In case of a fan failure, it can shorten the life of the product so please contact the service personnel.

Fan InformationA error occurs in the fan.Refer to the manual.

LIVE 04

live _19