Regulatory Information

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help.

CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate this equipment.

Part 68 of FCC Rules

This equipment complies with Part 68 of the FCC Rules. On the modem board inside full featured base stations is a label that contains, among other information, the FCC registration number and ringer equivalence number (REN) for this equipment. If requested, this information may be provided to the telephone company.

The REN is used to determine the quantity of devices that may be connected to the telephone line. Excessive RENs on the telephone line may result in the device not ringing in response to an incoming call. In most, but not all areas, the sum of the RENs should not exceed five (5.0).

L’indice d’équivalence de la sonnerie (IES) sert à indiquer le nombre maximal de terminaux qui peuvent être raccordés à une interface téléphonique. La terminaison d’une interface peut consister en une combinaison quelconque de dispositifs, à la seule condition que la somme d’indices d’équivalence de la sonnerie de tous les dispositifs n’excède pas 5.

To be certain of the number of devices that may be connected to the line, as determined by the total RENs, contact the telephone company to determine the maximum RENs for the calling area.

This terminal cannot be used on telephone-company-provided coin service. Connection to Party Line Service is subject to state tariffs.

This equipment uses the following USOC jacks: RJ11C, RJ45 (WAN/Ethernet)

An FCC-compliant telephone cord and modular plug is provided with this equipment. This equipment is designed to be connected to the telephone network or premises wiring using a compatible modular jack that is Part 68 compliant. If this equipment causes harm to the telephone network, the telephone company will notify you in advance that temporary discontinuance of service may be required. If advance notice is not practical, the telephone company will notify the customer as soon as possible. Also, you will be advised of your right to file a complaint with the FCC if you believe it is necessary. The telephone company may make changes in its facilities, equipment, operations, or procedures that could affect the operation of this equipment. If this happens, the telephone company will provide advance notice in order for you to make the necessary modifications to maintain uninterrupted service. If trouble is experienced with this equipment, please contact 2Wire, or your local 2Wire distributor or service center in the U.S.A. for repair and/or warrant information. If the trouble is causing harm to the telephone network, the telephone company may request you to remove this equipment from the network until the problem is resolved. No repairs can be done by a customer on this equipment. It is recommended that the customer install an AC surge arrestor in the AC outlet to which this device is connected. This is to avoid damage to the equipment caused by local lightning strikes and other electrical surges.

RF Exposure Information

This device was verified for RF exposure and found to comply with Council Recommendation 1999/519/EC and FCC OET-65 RF exposure requirements.

Wi-Fi Only

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. For additional compliance information, please reference FCC ID: PGR2W2701.

24

Page 26 Page 28
Page 27
Image 27
2Wire 2701HGV-W manual Regulatory Information
Page 26 Page 28

2701HGV-W specifications

The 2Wire 2701HGV-W is a multifaceted gateway designed to meet the demands of home and small office environments by providing both DSL and broadband connectivity through robust performance. This device is particularly popular among internet service providers and consumers for its reliability and versatility.

One of the main features of the 2Wire 2701HGV-W is its ability to serve as an Integrated Access Device (IAD), combining a DSL modem, a router, and a firewall in a single unit. This all-in-one design helps simplify the installation process as users don't need to purchase separate components. The DSL modem supports ADSL and ADSL2+, allowing for high-speed internet access while maintaining compatibility with various DSL technologies.

In terms of network connectivity, the 2701HGV-W boasts four Ethernet ports for wired connections, enabling multiple devices to connect directly to the router. For wireless connectivity, it supports 802.11g and 802.11b Wi-Fi standards, providing the ability to connect a range of devices wirelessly. The Wi-Fi performance is enhanced with features like Wi-Fi Protected Access (WPA) and Wired Equivalent Privacy (WEP), ensuring secure connections.

Another significant characteristic is its firewall capabilities, which help protect the local network from external threats. The built-in Stateful Packet Inspection (SPI) firewall provides an additional layer of security by analyzing incoming and outgoing packets to detect potential threats. Users can also configure parental controls and access restrictions, allowing them to manage which sites can be accessed on their network.

The 2Wire 2701HGV-W is designed with user-friendliness in mind. The web-based interface makes it easy for users to set up and customize their network settings. Additionally, the device supports Quality of Service (QoS), enabling users to prioritize certain types of traffic, such as video streaming or online gaming, ensuring a seamless experience even when multiple devices are connected.

Overall, the 2Wire 2701HGV-W is a versatile and robust networking solution that combines essential features such as DSL connectivity, wired and wireless networking options, and security protocols. Its user-friendly design and integrated capabilities make it an excellent choice for individuals and small businesses looking for a reliable internet gateway. Whether for casual browsing, remote work, or streaming, this device meets various connectivity needs efficiently.
Top Page Image Contents