3Com 10/100BASE-T4 PCI manual RJ-45 connector

2-4 CHAPTER 2: INSTALLING THE ADAPTER

For both 10BASE-T and 100BASE-T4 Ethernet networks, the Fast EtherLink PCI adapter uses Category 3, 4, or 5 unshielded twisted-pair (UTP) cable. Refer to Appendix A for more information on cabling.

Figure 2-2 shows the backplate of an installed adapter with its RJ-45 connector.

L N K	T4
ACT 10 100	T4

RJ-45 connector

Figure 2-2 Connecting Twisted-Pair Cable

The Fast EtherLink 10/100BASE-T4 PCI adapter is equipped with an on-board transceiver for connection to twisted-pair cable. To establish a valid 10 Mbps connection, the cable must be connected to a 10BASE-T hub. To establish a valid 100 Mbps connection, the cable must be connected to a 100BASE-T4 hub.

Connect the network cable as follows:

1Make sure that the connector on your cable is wired appropriately for standard 10BASE-T or 100BASE-T4 adapters.