1Install the mounting plate as shown in the following illustration, on either a stud (or other hard wall surface), or onto drywall.
If installing into a stud or other | If installing into drywall, use |
secure vertical surface, use 2 screws. | 3 plastic anchors and 3 screws. |
n
n
n
n
n n
n
Allow for a clearance of at least 25 cm (10 Inches) between the ceiling and the top of the mounting plate.
Make sure that “UP” is correctly oriented, and align the mounting plate screw holes vertically.
For installation on a wall stud, install the top screw into the stud, as shown at left in the illustration, and then vertically align the mounting plate before installing the bottom screw.
For installation on to drywall, mark three screw holes using the mounting plate as a template for vertical alignment, as shown at right in the illustration above.
Use a
For drywall mounts, you can route the cable through either a side or center opening for a seamless appearance using one of the methods illustrated below. Alternatively, you can simply attach the Ethernet cable to the side of the unit, allowing it to trail along the wall.
If you have routed the Ethernet cable through the center opening, secure the cable on the hook located on the mounting plate as shown in the illustration below.
2Connect the Ethernet cable to the Ethernet port on the access point.
20
