3Com 5000 quick start Unpacking Procedure, Installing the SwitchModule

4 COREBUILDER® 5000 SWITCHMODULE QUICK START AND REFERENCE

IEC 825, Class 1 LED Device. For connection only to Class 1 LED Devices.

CLASS 1

LED PRODUCT

6.0Unpacking Procedure

Follow this procedure to unpack a SwitchModule:

1Verify that the SwitchModule is the model that you ordered by examining the model number on the side of the shipping carton.

2Remove the SwitchModule, in its antistatic bag, from the shipping carton.

3Following the instructions in Section 5.0, "Installation Precautions", remove the SwitchModule from the antistatic bag and inspect it for damage.

If the SwitchModule appears to be damaged, return it to the antistatic bag, repack it in the shipping carton, and contact your local supplier.

Keep the shipping carton and antistatic bag in which your SwitchModule was shipped for future storage or shipment.

4Record the serial number of your SwitchModule. Use the CoreBuilder 5000 SwitchModule Planning Chart that comes with this product.

5Ensure that the CoreBuilder 5000 SwitchModule Kit contains these items:

■CoreBuilder 5000 SwitchModule

■Release Note for CoreBuilder 5000 SwitchModules

■3Com DocsOnCD documentation CD-ROM (contains CoreBuilder 5000 SwitchModule User Guide)

■CoreBuilder 5000 SwitchModule Quick Start and Reference (this guide)

■CoreBuilder 5000 SwitchModule Command Reference

■CoreBuilder 5000 SwitchModule Planning Chart

7.0Installing the SwitchModule

You do not need to turn off the CoreBuilder 5000 hub to install or remove the SwitchModule. You can install the SwitchModule while the hub is operating (which is called a hot swap).

Before you start the installation process, read Section 3.3, "Software Prerequisites," and Section 5.0, "Installation Precautions".

To install a SwitchModule:

1Determine hub power. To ensure that the hub has enough power to support the new SwitchModule:

a Enter the SHOW POWER BUDGET command to see if sufficient wattage is available from the +5 volt,

–5 volt, and +12 volt supplies.

b Using the values in the following table, add up the total power requirements for the SwitchModules that you plan to install:

	Power Requirement at
Model Number	+5 Volts	–5 Volts	+12 Volts
3C96618M-TX-A	52 W	0.5 W	0.25 Watts
			for all
3c96620M-TP-A	25 W	0.5 W
			modules
3C96612M-TP-A	23 W	0.5 W
3C96624M-TP-A	30 W	0.5 W
3C96624M-TPL-A	25 W	0.5 W
3C96616M-BTP-A	35 W	1.0 W
3C96610M-F-A	33 W	0.5 W
3C96620M-F-A	50 W	0.5 W
3C96614M-FTP-A	30 W	0.5 W
3C96612M-FF-A	40 W	0.5 W
3C96604M-F-A	31 W	0.5 W
3C96612M-FC-A	57 W	0.5 W
3C96604M-TX-A	34 W	0.5 W
3C96604M-FX-A	35 W	0.5 W