3D Connexion 7318 instruction manual Corded Buttonhole

q

r

z

	w		Corded Buttonhole
			Machine setting
		e
			q Stitch pattern:
			w Stitch width:	4–5
			e Stitch length:	0.5–1
t			r Thread tension: 1 – 5
			t Presser foot:	Sliding buttonhole foot J

zWith the buttonhole foot raised, hook the filler cord on the spur at the back of the foot.

Bring the ends toward you under the foot, clearing the front end.

Hook the filler cord into the forks on the front of the foot to hold them tight.

q

q Spur w Forks

x

e

w

xDraw both of needle and bobbin thread to the

left. Move the slider toward you so that the top mark r on the slider meets the start mark e.

e Start mark r Top mark

t Needle thread y Bobbin thread

r		Lower the needle into the fabric at the setting
t	y	point and lower the foot.
		Depress the foot control gently and sew the
		buttonhole over the cord.
c		The sewing sequence is the same as the 4-
		step buttonhole.
		c Pull the left end of the filler cord to tighten it
		and cut the excess tails.
		To cut the buttonhole opening, refer to the
		instructions on page 22.

23