CABLE OR PAIR IDENTIFICATION
Transmitter Setup
Transmitter setup is the same to identify cables or pairs. However, Receiver setups are different.
Perform a battery test; then, connect the
Note: Cable Identification requires two
Clamp the
Press to turn the Transmitter on and select the 33 kHz frequency. LED indicates the frequency selection.
Press to change the high output level.
Receiver Setup
Connect a second
Note: Cable Identification requires two
Press to turn the Receiver on.
Press to select the highest toning frequency.
Check the first cable in the group by clamping the
the cable. Press and observe the numeric display, which is relative
signal strength. Remember the number and continue by clamping the
greater than the previous observation, press . If the signal strength is
less than before, ignore it. After checking all the cables in the group, the cable with the highest reading is the one being identified.
Page 12