3M 2210E manual Dyna Coupler Method

Models: 2210E

1 16

Page 7

Connect the Dyna-Coupler to the Transmitter front panel jack using the coupler cable.

Clamp the Dyna-Coupler around the cable below any bonds just before the cable enters the earth. The jaws of the coupler must fully close.

Press to apply Tracing signal and select the 33 kHz frequency. LED indicates frequency selection. (This key can also turn the unit on.)

Select high output level by pressing .

Transmitter setup is finished, now go to LOCATING A BURIED CABLE - Receiver Setup (Page 8).

Page 6

Image 7

Contents

Operators Manual Dynatel 2210E Cable LocatorTABLE OF CONTENTS INTRODUCTION INSTALLING OR REPLACING THE BATTERIES6LR14 cells 6 LR6 cells RECEIVER BATTERY TEST INITIAL RECEIVER CONFIGURATIONDANGER TRANSMITTER BATTERY TESTTransmitter Setup LOCATING A BURIED CABLEDirect Connect Method Receiver Setup PageDyna Coupler Method Induction Method LOCATING A BURIED CABLE Receiver SetupAbout Trace Modes LOCATING AN ACTIVE DUCT PROBE ADP DETERMINING CABLE DEPTH AND CURRENTDetermining ADP Depth LOCATING EMS MARKERS Locating Markers using the ReceiverLocating Markers while Tracing Cable Path Transmitter Setup CABLE OR PAIR IDENTIFICATIONReceiver Setup PAIR IDENTIFICATION OPTIONAL ACCESSORIESReceiver Setup Environmental TECHNICAL INFORMATIONTransmitter ReceiverDynatel is a registered trademark of 3M