DYNA-COUPLER Method | 3M 2273E, 2250E guide

DYNA-COUPLER METHOD

Cable Path

Connect the Dyna-Coupler to the Transmitter front panel jack using the coupler cable.

Clamp the Dyna-Coupler around the cable below any bonds just before cable enters the earth. The jaws of the coupler must fully close.

Press to turn Transmitter on. Press again to select 8 kHz, 33 kHz or 133 kHz.

Select high output level by pressing . Transmitter setup is finished,

now go to LOCATING A BURIED CABLE - RECEIVER SETUP (PAGE 10).

Page 8

Image 9

3M 2273E, 2250E manual DYNA-COUPLER Method, Now go to Locating a Buried Cable Receiver Setup

Contents

Dynatel 2250E/2273E Advanced Cable Fault Locator Table of Contents Introduction Installing or Replacing the Batteries Receiver Battery Test Initial Receiver Configuration Transmitter Battery Test Using External DC Power and 5 Watt OutputWatt Output Locating a Buried Cable Transmitter Setup Direct Connect Method Cable Receiver Setup DYNA-COUPLER Method Now go to Locating a Buried Cable Receiver Setup Induction Method Receiver Setup About Trace Modes Selecting Auxiliary Frequencies Selecting Passive Power Frequencies Determining Cable Depth and Current Using Current Indications During Locating Locating Sheath Faults 2273E only Cable path Red leg Determining ADP Depth Locating AN Active Duct Probe ADP Locating Markers using the Receiver Locating EMS MarkersLocating Markers while Tracing Cable Path Toning Aerial Faults Cable Identification Cable or Pair Identification Pair Identification Optional Accessories Transmitter Technical InformationReceiver Environmental Important Notice Telecom Systems Division