PAIR IDENTIFICATION
Receiver Setup
Press 
to turn the Receiver on.
Press 
to select Tone mode 
.
Connect the inductive probe to Receiver accessory jack using probe cable.
Press | to select the highest toning frequency (133 kHz). |
|
Insert Probe into the bundle of pairs (or group, if known) and press | . | |
Next, divide the pairs into two bundles and insert the Probe into each of the bundles and observe the numeric display. The bundle with the highest reading will contain the target pair. Continue by dividing the bundle with the target pair into two parts and checking each part for the highest signal. In this way the target pair will be isolated.
Page 20
