LOCATING A BURIED CABLE
Receiver Setup
Note: Key descriptions can be found on the side of the Receiver.
Press to turn the Receiver on.
Press to select the 50/60 Hz power frequency (see section on
Selecting Passive Power Frequencies on Page 12) for passive locating;
otherwise, select the same frequency as the Transmitter.
Press to adjust the speaker volume as needed: off, normal, high, or
high-expanded. The high-expanded setting causes the audio to cut off
below a certain threshold.
Press to select a locate mode (Peak , Null , or Diff
). To select Special Peak mode: from Peak mode, press and hold
then press to toggle between Peak and Special Peak modes.
While in Special Peak mode, the peak flag will flash.
Note: Peak, Special Peak, or Null mode may require re-setting the
Receiver gain. Press when the bar graph remains either fully open or
fully closed. This is not necessary in differential mode since the unit
automatically adjusts theReceiver gain.
Page 10