3M 7684-S-8 manual 6.0Install Termination, Counter-Clockwise, Vinyl Tape Marker

6.0Install Termination

6.1Slide the termination body onto the cable and remove core. Pull while unwinding, counter-clockwise, starting

with the loose end (Figure 7). Make sure the termination body (not the core) is butted up to the edge of the vinyl tape marker previously applied (Figure 7).

NOTE: Once the termination body makes contact over the mastic seal area, there is no need to continue supporting the assembly. DO NOT PUSH OR PULL ON THE TERMINATION ASSEMBLY WHILE UNWINDING THE CORE.

Counter-Clockwise
Vinyl Tape Marker
NOTE: The material being removed at this step is mixed polymers
and can be recycled with	waste.

Figure 7

6.2Connect ground braid to system ground according to standard practice.

Correct Installation of Termination on Tape Shielded Cable
Vi nyl Tape
Marker	Ridge at End of Cable
Ridge at End	Insulation Shield (Semi-Con)
of High-K Tube
Semi-Con Insulation Shield	Cable	Envioronmental Top
Stress Controlling Compound	Insulation	Seal
	Conductor
		High-K Stress
		Relief Tube
78-8117-0985-2 Rev C	7