3M 78-0013-4441-1-D Connector Termination and Final Steps, 3M One Pass Mini Fiber Pathway

3M™ One Pass Mini Fiber Pathway

14.0Connector Termination and Final Steps

14.1Terminate the fiber using a 3M™ No Polish

Connector or 3M™ Crimplok+ Connector.

3M™ One Pass Point-of-Entry Box (Hallway Side)

	Feed through from living unit
Anchor furcation tubing

14.2In buildings where the One Pass Fiber Pathway is not the horizontal cable pathway solution, terminate the hallway distribution cable (once a penetration hole is drilled) inside the living unit in a Point-of- Entry Box. Both the One Pass Mini Fiber Pathway and horizontal distribution cable will terminate here.

3M™ One Pass Mini Fiber Pathway
	Horizontal Distribution Cable
	Anchor Point
900-micron side	Jumper side of box

14.3After completing installation of the entire run of duct and terminating the connector, route the 900 µm fiber and install the connector in the adapter as shown.

900 µm Fiber

Connector

Adapter

Snap

Locations

14.4Attach the cover by aligning the bottom tabs to slots in the base of the box, and then snap the cover in place.

14.5The tabs on the cover will hold the duct in place.

Tab secures duct

14.6Align the connector to the adapter and plug. Slide the door closed.

10 78-0013-4441-1-D