3M™ One Pass Mini Fiber Pathway
•Do not remove duct from box. Route end through handle as shown and pay off duct.
6.3Pull the two sections of duct apart to expose the fiber.
6.0Exposing Fiber For Termination
Expose
6.1Snip the flange on either side of the duct, being careful not to cut the fiber in the duct.
Cut flange on both
sides of duct
Do not cut into fiber inside duct
Pull straight
apart
7.0Wall Outlet Installation
The beginning and the end of the One Pass Mini Fiber Pathway must be held down mechanically. This is accomplished with the cover of the wall outlet box and the
7.1Attach the wall outlet base to the wall using two screws (and anchors if necessary).
7.2There are 12 ways to route the One Pass Mini Pathway Duct into the Wall Outlet. Select one and remove the
6.2 Twist the section to be removed 180°.
Breakaway tab locations
6 |