3M 78-0013-4441-1-D Wall Surface Compatibility, 3M One Pass Mini Fiber Pathway, c Splicer’s Knife

3M™ One Pass Mini Fiber Pathway

3.2ILU installation tools are wear items, and should be replaced on a bi-annual basis, or approximately every 500 installed units. Sooner as required.

3.3Additional Recommended Tools (Not Included)

A

B

D E

H

CG

F

a)Drill

b)Stapler

c)Splicer’s Knife

d)Fiber Snips

e)ScotchBlue™ Painter’s Tape

f)Level

g)Drill Bits - 5/16" (5 mm)

h)Pen

4.0Wall Surface Compatibility

The wall surface MUST be checked for compatibility with the adhesive backed One-Pass Mini Fiber Pathway prior to installation.

This test must be conducted on the most challenging surface of the installation path (greasy, soiled, textured etc). Or if installing on multiple wall surfaces, all surfaces must be tested and all must pass.

Incompatible surfaces include:

•Highly textured walls

•Porous or unfinished/unpainted brick or concrete

•Fabric wall surfaces

•Surfaces with flaking/delaminating paint or wallpaper

NOTE: The One Pass Mini Fiber Pathway should not be installed on the incompatible surface types listed above.

Wall Surface Compatibility Test Procedure

4.1Peel liner.

4.2Press firmly onto wall. Pressing with fingers in tight spaces is also OK.

Flat wheel

Along duct path

4 78-0013-4441-1-D