3M MP8625 manual Basic Operations, Projector Startup, Projector Shutdown

Section 3: Basic Operations

3.1 Projector Startup

RESET

MENU

MUTE INPUT

ON

LAMP TEMP

STANDBY/ON

ENGLISH

Figure 3.1 Projector Controls

1.Make all cable connections and line hookups with the power off.

2.Turn the POWER SWITCH of the projector on. The ON indicator will light up orange.

3.Press the STANDBY/ON button . The ON indicator blinks (green) and then lights (green). The ON indicator will blink green during warm-up and lamp ignition.

4.Adjust the screen size by rotating the ZOOM CONTROL.

5.Adjust the focus by rotating the projection lens.

6.Turn on all connected equipment. The method of connecting various equipment, see section 2.3.

7.Press the INPUT button on the projector or the INPUT SELECT (VIDEO or RGB) button on the remote to select the source of the signal to be projected on the screen. The selected signal input is displayed at the bottom right of the screen. The display will show the last selected input source before power was turned off.

3.2 Projector Shutdown

1.Hold the STANDBY/ON button for 3-5 seconds. The ON indicator blinks orange and the lamp turns off. After approximately 1 minute, the fan stops and the indicator stays orange.

2.Turn the MAIN POWER SWITCH

of the projector off.

Caution

Do not turn off the POWER SWITCH before pressing the STANDBY/ON button. After the STANDBY/ON button is pressed, the fan rotates for about 1 minute to cool the projector.

3.Disconnect cables.

© 3M 1998 3M™ Multimedia Projector MP8625 7