3M S10C Replacing The Lamp, Unscrew the 2 screws, and slowly, Pick up the lamp by the handles

Lamp (continued)

Replacing The Lamp

WARNING • Please carefully read the “Product Safety Guide”.

NOTE • Do not reset the lamp timer without replacing the lamp.

•When you replace the lamp, please replace also the air filter. The air filter may be attached when you buy a replacement lamp for this projector. Please ask your dealer.

If the indicators or a message prompts you to replace the lamp, replace the lamp as soon as possible. Using the lamp for long periods of time, or past the replacement date, could cause it to burst. If the projector is mounted on the ceiling, or if the lamp has broken, do not try to clean the projector or replace the lamp yourself.

1	Turn off the projector, and unplug the power cord. Allow the lamp
	bulb to cool for at least 45 minutes.
2	Contact your local dealer to prepare a new lamp. Tell the dealer
	your lamp type number. If the projector is mounted on the ceiling,

or if the lamp has broken, also ask the dealer to replace the lamp.

In the case of replacement by yourself,

After making sure that the projector

3 has cooled adequately, slowly flip over the projector, so that the bottom is facing up.

4 Unscrew the screw of the lamp door, then slide and take the lamp door up.

Lamp door

Screw

5	Unscrew the 2 screws, and slowly
	pick up the lamp by the handles.
	Insert the new lamp, and tighten the 2
6
	screws firmly to lock it in place.

Handles

Screws

7

8

Slide the lamp door into place until it locks into position.

Slowly turn the projector so that the top is facing up.

Turn on the projector, and reset the lamp timer. When the lamp has

9 been replaced after the message of “THE POWER WILL TURN OFF AFTER 0hr.” is displayed, complete the following operation within 10 minutes of switching power on.

(1)While the projector running, press the MENU button to open the menu.

(2)Choose the “OPTION” on the menu using the / button, then press the button or ENTER button.

(3)Choose the “LAMP TIME” using the / button, then press and hold the button of projector or the RESET button of remote control for 3 seconds.

(4)Choose the “RESET” using the button.

33