Operating (continued)
Using The Magnify Feature
VIDEO | RGB SEARCH |
ASPECT | AUTO BLANK |
MAGNIFY | VOLUME |
ON |
|
| MUTE |
OFF |
|
FREEZE | KEYSTONE |
POSITION | MENU |
| ENTER |
ESC | RESET |
1 | Press the MAGNIFY (ON) button. | MAGNIFY | ON | |||
|
|
|
|
|
| |
| The projector enters MAGNIFY mode. |
|
| |||
2 | Press the POSITION button, then use the |
| ||||
| , | , | , | buttons to select the area | ||
| to zoom. Press the POSITION button again | |||||
| to finalize the zoom area. |
|
| |||
|
| POSITION |
| POSITION |
|
|
3 Use the | , | buttons to adjust the zoom |
level. |
|
|
Press the MAGNIFY (OFF) button to exit MAGNIFY mode and restore the screen to normal.(The projector will also automatically exit MAGNIFY mode if there is a change in the input signal's state.)
NOTE • The projector will automatically exit from MAGNIFY mode if either the SEARCH, RGB, AUTO, ASPECT or VIDEO feature is used, or, if there is a change in the input signal's state.
•The correcting keystone condition may vary when the magnify function is active. In this case, please make the magnify OFF, so the correcting keystone condition will be restored.
Freezing The Screen | ||
|
| FREEZE |
ON | MUTE | 1 Press the FREEZE button. |
OFF |
| The [II] icon appears and the screen will freeze |
FREEZE | KEYSTONE | at the current image. Press the FREEZE button |
|
| again and the [▲] appears as the projector exits FREEZE |
|
| mode. |
POSITION | MENU |
|
NOTE | • The freezing function will automatically finish if either the STANDBY/ON, | |
SEARCH, RGB, VIDEO, BLANK, AUTO, VOLUME, MUTE, POSITION or MENU button of remote control is pressed, or if a button of projector is pressed, or if there is a change in the input signal’s state.
•If the projector continues projecting the same image for a long time (i.e. you forget to exit FREEZE mode), the image might possibly remain as an afterimage. Do not leave
the projector in FREEZE mode for too long.
20
