Part Names
The Projector
Remote sensor 13
Indicates the corresponding reference page
15Focus ring
15 Zoom knob
34
Lens |
| Air filter cover |
| (An air filter is | |
(The picture is |
| |
| inside.) | |
projected from here.)) |
| |
|
| |
|
| 8 Elevator button |
| Projector (Front/Right) | 8 Elevator feet |
|
|
Attaching The Base
CAUTION • Be careful not to pinch your finger on the occasion of the handling of a base. ・Do not hold the base, lens or other project part to move the projector.
•Do not use the base to suspend the projector.
•Do not push or put anything on the both sides of the top of the projector.
1 | Turn off the projector, and unplug the power cord. Allow the lamp | ||
| bulb to cool for at least 45 minutes. | ||
|
|
| |
| After making sure that the projector | ||
2 | |||
| has cooled adequately, slowly flip | ||
| over the projector, so that the bottom | ||
| is facing up. | ||
|
|
| |
|
|
| |
| Put the base on the bottom of the | ||
3 | |||
| projector, as shown in the fugure. | ||
| Then slide it to the back of the projector | ||
| until it locks into position. | ||
| To remove it, slide the base to the front | ||
| of the projector pinching the lever | ||
| of the base. | ||
|
| ||
|
|
| |
| Slowly turn the projector so that the top is facing up. | ||
4 | |||
|
| ||
4
