4. Utilize projector – Advanced -
4.8 Command Control via the Network
You can configure and control the projector via the network using
Communication Port
The following two ports are assigned for the command control. TCP #23
TCP #9715
NOTE • Command control is not available via communication port (TCP #9716) that is used for the
Command Control Settings ( 25)
Configure the following items from a web browser when command control is used.
Example: If the IP address of the projector is set to 192.168.1.10:
1)Enter [http://192.168.1.10/] into the address bar of the web browser.
2)Enter the Administrator ID and Password and click [Logon].
3)Click [Port settings] on the main menu.
4)Click the [Enable] check box to open [Network Control Port (Port: 23)] to use TCP #23. Click the [Enable] check box for the [Authentication] setting when authentication is required, otherwise clear the check box.
5)Click the [Enable] check box to open [Network Control Port (Port: 9715)] to use TCP #9715. Click the [Enable] check box for the [Authentication] setting when authentication is required, otherwise clear the check box.
6)Click the [Apply] button to save the settings.
75