Appendix: Greeter Module
November 6 2014 – Revision 2.1
Page 64 of 77
3M™ Drive-Thru Systems Model G5 and Model XT-1
Operating Instructions
h)
Message Names
Message Activation
Perform the following procedure to schedule and activate GREETER and
REMINDER messages.
Note:
This step should be done after Daypart Definitions have been configured and
Messages Recorded.
1.
Enter the greeter configuration menu.
2.
Select
1 Message Activation
.
Act.<NO > :MESSAGE ACTIVATION: Msg.<001><MON> [Breakfast 1 ][GREETER] [ Breakfast ]<NO >
[ Morning ]<NO > [ Lunch ]<NO >
[ Afternoon ]<NO >
3.
Using the
,
,
,
and
Enter
keys, select a message number and
day of the week to configure.
Msg.<001><MON>
4.
For the selected message, set the value to “YES” for each daypart the
message is active,
[ Breakfast ] <YES>
, leaving the other
dayparts set to
[ Morning ] <NO >
5.
Repeat the daypart assignments for each day of the week.
Msg.<001><TUE>
6.
When done, activate the message schedule by selecting “YES”.
Act.<YES>
7.
Repeat steps 3 – 6 for each message you wish to schedule and activate.
Record Message
After determining the number and type of messages to use in the drive-thru
operation, the user will then record each message into the Greeter Module
memory.
Perform the following procedure to record and playback messages:
1.
Enter the greeter configuration menu.
2.
Select
2 Record Messages
.
:RECORD MESSAGES: Msg.<001> Type:<GREETER > [REC.] [PLAY] Duration:<00> Time:[

] Name:<Breakfast 1 > {Mode=Exit}
Note:
If you store a new message in an occupied slot, the old greeter message will
be permanently erased.
Each recorded message can be no more than 8 seconds long (GREETER,
CLOSED, FORWARD) or 4 seconds long (REMINDER, ALERT)
3.
Put on a working headset with the power on.
4.
Using the
,
,
,
and
Enter
keys, select a message number to
record.
Msg.<001>
.