INSTALLING THE POINT
OF USE WATER HEATER
(SEE PAGE 2 FOR TYPICAL INSTALLATIONS)
OPTIONAL WALL MOUNTING
WARNING
WALL CONSTRUCTION AT THE POINT OF THE WATER HEATER INSTALLATION MUST BE CAPABLE OF SUPPORTING AT LEAST 200 POUNDS.
As an example: if the water heater is to be installed on a wall of gypsum board (dry wall) or other material not capable of supporting the water heater filled with water, additional bracing will be necessary. Two possibilities are shown in Figure 6 below.
FIGURE6
1.Using two sheet metal screws supplied, secure the top mounting bracket to the top of the water heater.
FIGURE7
2.Using the remaining two sheet metal screws provided, secure the bottom mounting bracket to the bottom of the water heater.
FIGURE8
3.Determine the location on the wall, and then the height above the floor which the wall securing bracket will be placed. Using adequate screws, or nuts, and bolts (not supplied) fasten the wall securing bracket to the wall.
FIGURE9
For more information not listed in this section please referee to sections on pages 3, 5 and 6. One must read all sections listed below in this manual to insure your heater is installed correctly.
INSTALLATION
REQUIREDABILITY
GENERAL
WATER HEATER LOCATION
WATERCONNECTIONS
TEMPERATURE AND PRESSURE RELIEF VALVE
CLOSED WATER SYSTEM
ELECTRICAL CONNECTIONS
OPERATION
FILLING
MAINTENANCE
RELIEF VALVE
ANODERODEMAINTENANCE
7