BASIC OPERATION
SPEED DIALING
Making Calls
1. Pick up the handset from the base and press T. |
The LED on the handset will flash while the |
handset is scanning for a clear channel. The LED |
will glow steadily when a connection is made. Wait |
until you hear a dial tone. |
Redial Key Flash Key
Key
2.4 GHz
The
Storing Phone Numbers
1. With the handset in the idle state, press l. The |
phone will beep and the IN USE LED will flash. |
Redial Key
In Use LED
2.4 GHz
2. | Dial the number you wish to dial. |
3. | When you are finished talking, press the Tkey or |
| place the unit back into the base to end the call. |
In Use LED
Talk Key
In Use/
Low Batt.
In Use/
2. Dial the number you wish to store (up to 16 digits). |
Note: Press Rto insert a dialing pause into the number. The pause lasts for 4 seconds and uses one digit of the 16 digits available.
Low Batt.
Talk Key
Note: The IN USE light on the handset will illuminate | Temporary |
when the line is active. | Tone Key |
|
| Mute | MEM |
| Mute Key |
|
3.Press l.
4.Press the dial pad key for the location where you wish to store the number. The handset will give a confirmation tone.
MuteMEM
Memory Key
Receiving Calls
When you hear the phone ring:
1.If the handset is in the base, lift the handset from the base. The handset will turn on. There is no need to push the Tkey if the unit is on the base when the call comes in.
2.If the handset is off the base, you will need to press Tto answer the call.
3.When you are finished, push Tor place the handset back on the base.
Additional Options
To: | Do This: |
Redial the last number | Press T. Wait for dial tone and then press R. |
Adjust the volume in the | Press during a call until the desired volume level |
earpiece | is reached. |
Switch to temporary tone | Press the *key after the phone is in use. The phone |
dialing | will remain in tone dialing mode for the duration of the call. |
Receive a call waiting call | Press Eto go to the new caller. |
| Press Eagain to go back to the original caller. |
Mute a call | Press the Lkey. |
| Press Lto continue speaking to the caller. |
|
|
Note: If you make a mistake the handset will give two quick beeps to let you know that the number was not stored.
Making Speed Dial Calls
1.Push T. The LED on the handset will flash while the handset is scanning for a clear channel. The handset In Use LED will glow steadily when a connection is made. Wait until you hear a dial tone.
2.Press land the dial pad key location where the number is stored.
3.When you are finished with your call, press T, or place the handset back on the base.
Note: It is possible to “Chain Dial” stored numbers. Simply repeat steps 2 and 3 for each additional number you wish to dial during the same call.
Deleting a Stored Number
1.With the handset in the idle state, press l. The handset will beep.
2.Press Rand then press l. After each press the phone will beep.
3.Press the dial pad key location of the stored number that you want to delete. The handset will give a confirmation tone.
17 | 18 |
|
|
