Getting Started
This section describes phone behaviour and start up screens you may see when the 9133i phone is first plugged in, or when it is restarted.
When You First Plug in Your Phone
The 9133i automatically begins the start up sequence as soon as it is connected. The phone goes through this process the first time you plug in your phone and every time you restart your phone. The first screen the phone displays is the Aastra splash screen.
Updating Your Phone
After displaying the Aastra splash screen, the 9133i checks settings and looks for new configuration and firmware updates for the phone from the server. If a new update is found, the phone displays the message <Updating Config> or <New Firmware>. This may take a few moments while the phone downloads the latest updates.
NOTE: New updates to your phone can be automatically scheduled from the server. This is set up on the phone system by your system administrator and should be scheduled during
Important! Do not unplug or remove power to the phone while it is checking or installing firmware.
Start up Screens |
|
| Getting | ||
After the phone displays the Aastra | |||||
| |||||
splash screen or after downloading an |
| ||||
update, the phone displays the Idle |
| ||||
State screen: |
|
| Started | ||
The basic Idle State screen lists your | |||||
| |||||
name, extension, and today's date and |
| ||||
time. This screen is shown whenever |
|
| |||
your phone is not in use. |
|
|
| ||
Incomplete Config. |
|
|
| ||
If your phone displays a <No |
| ||||
Service> | message | without | any |
| |
extension or user name at the end of the |
| ||||
start up sequence instead of the Idle |
| ||||
State screen, this means your system |
| ||||
administrator has not set up your |
| ||||
extension | correctly. | Contact | your |
| |
system administrator for assistance.
No Service
The <No Service> or <Network Disconnected> prompt appears on the display and the telephone status light turns on when the phone is not properly connected to the network, or the account has not been configured by the administrator. The phone also displays the default time and date of 12:00am Jan 1st, 2000. Check that the cables are tightly connected to the phone and to the wall jack. The phone should automatically detect when the connection is reconnected and
will display the <Network Connected> prompt temporarily. If changes have been made to your phone settings, you may need to restart your phone. See the following section “Setting Your Options” for instructions on how to restart your phone.
2
