Chapter 1 – System Housing 1-7
1.5 Installing Drives
Turn off the power switch and unplug the
power cord before installing or removing
drives. See section 2.6 for important ESD
precautions and pre- and post-installation
instructions.

1.5.1 3.5-inch Drive

To install 3.5-inch drives:
1. Open the front panel of the housing. See section 1.4 for more information on
opening the housing panel.
2. Detach the 3.5-inch drive frame (2 pieces) from the housing by removing two
screws. Keep the screws for later use.
3. Attach the drive frames to the 3.5-inch drive securing it with four screws as
shown below.