80 Troubleshooting
System Check Procedures

Diskette Drive Check

Do the following to isolate the problem to a controller, driver, or diskette. A
write-enabled, diagnostic diskette is required.
Note:

Make sure that the diskette does not have more than one label

attached to it. Multiple labels can cause damage to the drive or

cause the drive to fail.

Do the following to sele ct the test device.
1. Boot from the diagnostics diskette and start the PQA program.
2. Go to the diagnostic Diskette Drive in the test items.
3. Press F2 in the test items.
4. Follow the instructions in the message window.
If an error occurs with the internal diskette drive, reconnect the disk ette
connector on the system board.
If the error still remain s:
1. Reconnect the diskette drive.
2. Replace the diskette driver cable.
3. Replace the diskette.
4. Replace the system board.

CD-ROM Drive Check

Do the following to isolate the problem to a controller, drive, or CD-ROM.
Make sure that the CD-ROM does not have any label attached to it. The label
can cause damage to the drive or can cause the drive to fail.
Do the following to sele ct the test device:
1. Boot from the diagnostics diskette and start the PQA program.
2. Go to the diagnostic CD-ROM in the test items.
3. Press F2 in the test items.
4. Follow the instructions in the message window.
If an error occurs, reconnect the connector on the System board. If the error
still remains:
1. Reconnect the CD-ROM drive.
2. Replace the CD-ROM drive.
3. Replace the system board.