Chapter 4 59
Device Address Conflict Run “Load Default Set tin gs ” in BI OS Set up Utility.
RTC battery
System board
Allocation Error for device Ru n “Load Default Settings” in BIOS Setup Utility.
RTC battery
System board
Failing Bits: nnnn DIMM
BIOS ROM
System board
Fixed Disk n None
Invalid System Configurat ion Data B IOS ROM
System board
I/O device IRQ conflict Run “Load Default Settings” in BIOS Setup Utility.
RTC battery
System board
Operating system not found Enter Setup and see if fixed disk and drive A: are properly identified.
Diskette drive
Hard disk drive
System board
Error Message List
No beep Error Messages FRU/Action in Sequence
No beep, power-on indicat or turns off and LCD is
blank. Power source (battery pack an d power adapter). See “ Power
System Check” on page 55.
Ensure every connector is connected tightly an d correctly.
Reconnect the DIMM.
LED board.
System board.
No beep, power-on indicator t urns on an d LCD i s
blank. Power source (battery pack an d power adapter). See “ Power
System Check” on page 55.
Reconnect the LCD connector
Hard disk drive
LCD inverter ID
LCD cable
LCD Inverter
LCD
System board
No beep, power-on indicator t urns on an d LCD i s
blank. But you can see POST on an extern al
CRT.
Reconnect the LCD connectors.
LCD inverter ID
LCD cable
LCD inverter
LCD
System board
No beep, power-on indicator turns on and a
blinking cursor shown on LCD during POST. Ensure eve ry connector is connec ted tightly and correctly.
System board
No beep during POST but system ru ns correctly. Speaker
System board
Error Message List
Error Messages FRU/Actio n in Sequence
340SG.book Page 59 T hursday, October 28, 1999 10:51 AM