Acnodes FPC 8084 Initializing the PenMount driver, Demonstration, 3.2.4Driver Installation- Linux

FPC 8084 User’s Manual

right-center point, bottom-center point and left-center point in sequence. After calibration, the data is shown in the screen, press any key to continue the progress.

3.After the calibration, suggest you to test touch screen and display mapped results by choose “3” DRAWING TEST under PM.BAT

3.2.3.4 Initializing the PenMount driver

If you don’t have the initialization commands in AUTOEXEC.BAT, initialize PenMount C:\PENMOUNT\PMINIT) controller before you use the PenMount Touch Screen. The display will show the initialization message:

PenMount V7.06 Copyright(c) SALT International Corp. Test:COM<n> IRQ<n> (<n> is the number after PMDETECT done) PenMount communication settings: COM<N> IRQ<n> Baud Rate: <xxxx>

... ... ... ... ... ... ... ... ... ...

3.2.4.5 Demonstration

To demonstrate or test touch screen operation, selecting “3”

DRAWING

TEST in PM.BAT file of Utility Directory. Drawing on screen.The other demonstration program called “ICECREAM.EXE” in the “PENMOUNT” directory can also be applied.

3.2.4Driver Installation- Linux

.3.2.4.1 Advance Setup

1.Before install the Touch Screen Driver, please open the file in Linux

File /etc/rc.local

29