Acu-Rite 1025 5-in-1 Sensor Setup, Back of Display Unit, Back Of Display Unit, Mac Address, Reset

SETUP

Back of Display Unit

1 2 3

4

5

7 6

8

9

10 11

5-in-1 Sensor Setup

11. Install or Replace Batteries

Batteries MUST be installed for this product to operate. AcuRite recommends high quality alkaline or lithium batteries for the best product performance. Heavy duty or rechargeable batteries are not recommended.

The 5-in-1 sensor requires lithium batteries in low temperature conditions. Cold temperatures can cause alkaline batteries to function improperly. Use lithium batteries in the 5-in-1 sensor for temperatures below -4ºF / -20ºC.

1.Slide off the battery compartment cover.

2.Insert 4 x AA batteries into the battery compartment, as shown.

Follow the polarity (+/-) diagram in the battery compartment.

3. Replace the battery cover.

22. Remove Rain Gauge Stabilizer

Locate and remove the rain gauge stabilizer (plastic tab) taped into the bottom of the sensor. The rain gauge will not function until this is removed.

33. Set the A-B-C Switch

Locate the A-B-C switch inside the battery compartment. Set the A-B-C switch to A, B or C. You must select the same letter choices for both the sensor and the display unit in order for the units to synchronize.

BACK OF DISPLAY UNIT

1.Plugin for Power Adapter

2.Plugin for USB Cable

3.Integrated Hang Hole for easy wall mounting

4.MAC ADDRESS

12-digit unique ID required for online connectivity functions.

5.A-B-C Switch

ID code that must match 5-in-1 sensorʼs A-B-C switch to ensure units synchronize.

6.Battery Compartment

7.Clear Today

Clears data recorded since 12:00am.

8.Clear All

Clears all data recorded.

9.Reset

Full reset to factory defaults.

10.Power Adapter

11.USB Cable for PC Connection

12.Battery Compartment Cover

(not shown)

A B C

A-B-C Switch

3set to match display unit

1	Install Batteries		Rain Gauge Stabilizer
		2
	4 AA batteries		Remove and discard

6 7