Adder Technology ADD0038/1 SVXPRO Datfilename.DAT, SVXPRO 4X16V129.DAT, SmartView XPro, Page

Like the hex files, the first three digits represent the model number (e.g. 2X8 represents a SmartView 2XPro with 8 computer ports). The next four digits represent the version number (e.g. V129 equals firmware version 1.29).

To upgrade the SmartView, check that the DAT file designation matches the model that you have. In other words, if you have a SmartView 2XPro with 8 computer ports and you want to upgrade to version 1.30 then the DAT file that you need would be named 2X8V130.DAT. Also check that all the required files are loaded into the same directory on your computer. From that directory run the upgrade file using the following command line.

SVXPRO {Dat_file_name}.DAT

Where {Dat_file_name} is the name of the required DAT file

For example, if the name of the required DAT file is 4X16V129.DAT then use the following command line:

SVXPRO 4X16V129.DAT

Follow the instructions given on the screen to perform the upgrade. When the upgrade is complete the program will confirm that the upgrade has been successful and then quit.

Step 7 - Switch the UPGRADE key to the OFF position and cycle the power

Switch the UPGRADE switch on the rear of the SmartView to the OFF position and disconnect the power. When the power is re-applied the SmartView will operate using the new firmware.

SmartView XPro Installation and Use Page 58