ADIC Server manual Eswitchinprog, Enopool, Eareafull, Ehicapinuse, Enodoubleside, Eexup, Eprobdev

Table A-1	Error Code Reactions
Number	d_error Name	Recommended Reactions to the Error Code
35	ESWITCHINPROG	The commands can not be executed. DAS and
		AMS are being switched to the other AMU. Wait
		until the switching process is completed and try
		again.
36	ENOPOOL	There has been an attempt to insert or eject
		cleaning cartridges to a cleanpool that has not
		been configured. Confirm the cleanpool name in
		the command with the cleanpool names in the
		AMS configuration.
37	EAREAFULL	The aci_ejectclean command returns that the Eject
		area is full. Empty the area and try the command
		again.
38	EHICAPINUSE	The commands can not be executed, because the
		HICAP is open and the robot is not ready. Close
		the HICAP, press the start button on the
		controller and try the command again.
39	ENODOUBLESIDE	The volser in the aci_getvolsertoside command
		was not from type optical disk (AMU mediatype
		O0 and O1)
		Check the AMS configuration and AMU
		database.
40	EEXUP	The aci_driveacess command returned that the
		requested drive is exclusively used by a other
		client. Request the other client to release the drive
		or use the Client DAS_SUPERVISOR for the
		release.
41	EPROBDEV	AMS returned <1033> (position not in AMU
		database). Check the AMU database, use AMS
		command update device for actualizing the
		database.
42	ECOORDINATE	AMS returned <1142> (the logical coordinate is
		not in the AMS configuration). Compare the AMS
		configuration with the DAS parameter in the
		command.
43	EAREAEMPTY	Returned AMS <1156> (Insert area empty) during
		insert. Open and close the I/O unit, the AMS will
		start the automatic inventory of the range.
44	EBARCODE	Switch the bracode reading off with aci_barcode
		and try the command again

A-8 Application Notes

601626-B