ADT Security Services 400 Before you Begin

5. Voice Alarm Systems Before you Begin

24 Unimode 400 Operations PN 50709:A 10/20/97

Before you Begin

Before operating the VAS, make sure the system is fully installed according to the

instructions in the Unimode400 Installation manual. For more information about audio

system components, configurations, connections, and programming, refer to the

following manuals:

Table 18 Additional Sources of Information

For information on the following... Refer to...

Installing Voice Alarm System

components, including speaker/

telephone circuits, amplifiers, and

modules.

Unimode400 Installation Manual

Programming speaker and

telephone circuits

Unimode400 Programming Manual

VROM (Voice ROM) Series Messages Document 15945

Contents

Main Installation Precautions - Adherence to the following will aid in problem-free installation with long-term reliability: Fire Alarm System Limitations FCC Warning Table of Contents 1. Introduction 2. Using the Control Panel 3. Operating Modes 4. Read Status 5. Voice Alarm Systems 1. Introduction Operating Features Components Page 2. Using the Control Panel Table 1 lists the controls and indicators and where to find information on their use: Table 2 Descriptions of System Status Indicator LEDs Table 1 Control and Indicators System Status Indicator LEDs Control Keys 3. Operating Modes Normal Operation Trouble Operation Fire Alarm Supervisory Signal Non-Alarm Point Operation Trouble Monitor Point Operation Notification Appliance Circuit (NAC) Operation Control-By-Event Operation Releasing Functions Page 3. Operating Modes Intelligent Detector Functions Intelligent Detector Functions Table 7 contains descriptions for intelligent detector functions used with the control panel. Table 7 Intelligent Detector Functions Pre-Alarm Operation (AWACS) Pre-Alarm Operation (AWACS) Table 8 Control Time Functions Time Functions Overview The control panel includes a real-time clock that provides time-of-day, date, and day- Page ! Page 4. Read Status Page Read Status Options Table 13 contains descriptions of the fields shown in Figure 12: Table 13 Default Read Status Values for a Detector Read Status for a Zone Address Page Page Page Read Status Options System Parameters To read System Parameters, follow these steps. Table 15 System Parameters Table 15 contains descriptions of the items shown on System Parameter Screen (Figure 22): Page 5. Voice Alarm Systems Operating Features In this Section Before you Begin AMG-1/AMG-EAudio Message Generator 5. Voice Alarm Systems AMG-1/AMG-EAudio Message Generator Operating the AMG-1 Figure 27 shows the AMG-1 operating controls: Table 21 contains instructions for operating the AMG-1. Table 21 AMG-1 Operating Instructions Selecting AMG Group Functions Selecting AMG Tones and Messages Selecting AMG Tones and Messages Unimode 400 Operations PN 50709:A 10/20/97 29 AMG-1 and AMG-E Tone/Message Selections (AMG-1 SW2=Off) Table 23 lists the tone and message selections available when SW2 rocker switch2 (Tone/Message Switch) is Off. S6 S7 S8 5. Voice Alarm Systems Selecting AMG Tones and Messages 30 Unimode 400 Operations PN 50709:A 10/20/97 AMG-1 and AMG-E Tone/Message Selections (AMG-1 SW2=On) Table 24 lists Status NAC 1 (B01) the tone and message selections available when SW2 rocker switch 2 (Tone/Message Switch) is On. ATG-2 Audio Tone Generator Page Page Fire Fighter's Telephones (FFT-7/FFT-7S) Audio Amplifiers AA-30 Audio Amplifiers AA-100/AA-120 Audio Amplifiers Adjusting the Audio Gain Level (AA-30, AA-100/AA-120) ! Selecting the AA-100/AA-120 Backup Tone AMG Voice Message Options